background image

B.O.B. 1500 AIR LIFT

INSTRUCTIONS

l

PARTS DRAWING

PARTS LIST

PART NUMBERS: 14472 - 16759 - 17008 

WARNING: READ INSTRUCTIONS BEFORE OPERATING

1. Center load on table - 1500 lb. maximum.

2. Connect to 100 psi maximum shop air.
3. Keep safety bar in position at all times - except  

when lowering.

4. Keep hands and tools from under carriage.
5. Do not mount table when in elevated position.
6. Do not ride vehicle onto lift.
7. Lift must be in the lowered position when moving.
8. Only trained persons should operate Air Lift.
9. The working area should be sufficiently lit.

10. Foot controller should be at least 3 feet away from

Air Lift during raising and lowering operation

11. Recommended for indoor use only.

HANDY DIVISION OF JADEIM, LLC

401 South 2nd. Marshalltown, IA  50158   Ph: 855-752-5446    Fax  641-752-1205  www.handyindustries.com

Summary of Contents for Handy B.O.B. 1500 AIR LIFT

Page 1: ...from under carriage 5 Do not mount table when in elevated position 6 Do not ride vehicle onto lift 7 Lift must be in the lowered position when moving 8 Only trained persons should operate Air Lift 9 The working area should be sufficiently lit 10 Foot controller should be at least 3 feet away from Air Lift during raising and lowering operation 11 Recommended for indoor use only HANDY DIVISION OF JA...

Page 2: ...aximum load of 1500 lbs 2 Loads must be firmly positioned and secured on table at all times 3 All moving parts have been lubricated at the factory and should be re lubricated every 6 months to prevent galling Grease zerks are located at each end of frame pivot shaft and at top ends of inside frame assembly 4 Lightly oil cylinder rod when it becomes dry 5 Squirt some oil through bleed hole in plate...

Page 3: ...aft seal 15379 cylinder assembly 15390 cylinder shaft assembly 15397 cam roller bearing 15400 retaining ring 2 3 8 15401 piston 15403 piston seal Part Description 15607 top assembly 15411 inside frame assembly 15431 outside frame assembly 15446 foot assembly 15452 ramp 15687 drop out cover 15458 detent bar 15460 frame pivot shaft 15461 cylinder pivot shaft 15462 retaining ring 1 1 4 15463 track ro...

Page 4: ...ip will be replaced or put in good operating condition This warranty does not apply to damage resulting from accident improper installation repair operation or maintenance negligence or neglect THE COST OF SUCH REPLACEMENT OR REPAIR SHALL BE EXCLUSIVE REMEDY FOR ANY BREACH OF ANY WARRANTY AND HANDY INDUSTRIES SHALL NOT BE LIABLE TO ANY PERSON FOR CONSEQUENTIAL DAMAGE OR INJURY OR COMMERCIAL LOSS R...

Reviews: