WHIRLPOOL
BATH
R
INSTALLATION
TREVI
™
FILL SPOUT
2-1/16"
25/32"
1-15/32"
7/32" DIA.
7/8" DIA.
TOWARD INTERIOR OF BATH
MOUNTING SUFACE
OF FILL SPOUT
2-1/2"
MAX.
INTERIOR EDGE OF BATH RIM
HOLE DRILLING GUIDE
(SEE TEMPLATE NEXT PAGE)
INSTALLATION ON BATH
INSTALLATION
1. Drill a 7/8" diameter hole in the deck with a 1/4" diameter hole 13/16" (center to center) away from the 7/8" hole.
Drill the second hole so that the fill spout is oriented properly toward the bath. Use drilling template on next page.
2. Install set screw and fill spout washers.
3. Install fill spout through the 7/8" diameter hole while aligning the set screw to the 1/4" hole.
4. From the underside of the bath rim install the rubber washer, metal washer and nut as shown. Tighten the nut.
5. Connect water supply hose (not provided) from the mixer valve.
FILL SPOUT
BATH SHELL
RUBBER WASHER
METAL WASHER
SET SCREW
1/2" FLEXIBLE FAUCET
CONNECTOR (NOT
PROVIDED)
NUT
SET SCREW O-RING
FILL SPOUT WASHER
MOUNTING NUT
GASKET
BATH SHELL
MOUNTING NUT
GASKET
NUT
COMPRESSION
CONE
GROMMET
FLAT SEAT
NUT
TO FILL
SPOUT
MAXIMUM OF
ONE THREAD
BRASS WASHER
HOLE SIZE
FOR VALVE
1-1/4" DIA.
1/4" DIA.
Drilling Holes for Valves
Drill holes from the finished surface side of the unit very carefully, making sure they are the proper size. We
recommend that you drill pilot holes and then use the recommended drill size. Mount the valve as shown
Summary of Contents for TREVI
Page 4: ......
