![background image](http://html.mh-extra.com/html/inspire/ns1003/ns1003_installation-manual_2068855001.webp)
Inspire Home Automation
www.inspirehomeautomation.co.uk
[email protected]
01202 798390
1
1
NS1003 Installation Guide
Rev 1.1
WARNING Electricity is dangerous.
Before commencing work, ensure that you read and understand these instructions and isolate
the relevant circuit.
This product should only be installed by a qualified electrician or heating engineer
and should be installed
in accordance to BS 7671 (IEE Wiring Regulations), or to another equivalent standard.
CAUTION: High Voltage Wires
The NS1003 series is designed to control a typical domestic central heating system. The Relay module
can switch three independent channels. This would usually be the 2 Central Heating Zones and the Hot
Water or 3 Central Heating Zones.
The central heating channel is switched on and off in response to commands from the supplied Wireless
Thermostat.
The Hot Water channel is switched on and off at the programmed time intervals that the user sets.
Whats in the box
Introduction
2(or 3) x Assembled Room Thermostat consisting of
1 x Room Thermostat
1 x Wall Mount
1 x Assembled Relay Module consisting of
1 x Control Board
1 x Wall Mount
1 X Front Cover
1 x Gateway
1 x Network Cable
1 x Power Supply
2(or 3) x Thermostat screw pack
1 x Relay Module Screw Pack
4(or 6) x Batteries
Gateway
Room Thermostat
Relay Module
Relay Module
Screw Pack
Thermostat
Screw Pack
Batteries Network Cable
Power Supply