Inspire Home Automation
www.inspirehomeautomation.co.uk
[email protected]
01202 798390
1
1
NS1002-1ch Installation Guide
Rev 1.0
WARNING Electricity is dangerous.
Before commencing work, ensure that you read and understand these instructions and isolate
the relevant circuit.
This product should only be installed by a qualified electrician or heating engineer
and should be installed
in accordance to BS 7671 (IEE Wiring Regulations), or to another equivalent standard.
CAUTION: High Voltage Wires
The NS1002-1ch series is designed to control a typical Combi Boiler setup. It can switch a single output
channel. The central heating channel is switched on and off in response to commands from the supplied
Wireless Thermostat.
The Hot Water channel is not used.
Whats in the box
Introduction
1 x Assembled Room Thermostat consisting of
1 x Room Thermostat
1 x Wall Mount
1 x Assembled Relay Module consisting of
1 x Control Board
1 x Wall Mount
1 X Front Cover
1 x Gateway
1 x Network Cable
1 x Power Supply
1 x Thermostat screw pack
1 x Relay Module Screw Pack
2 x Batteries
Gateway
Room Thermostat
Relay Module
Relay Module
Screw Pack
Thermostat
Screw Pack
Batteries Network Cable
Power Supply
