A
U
T
O
M
A
T
I
C
P
O
W
E
R
P
I
P
E
C
L
E
A
N
E
R
M
I
N
I
R
O
O
T
E
R
User’s Instruction Manual
Model : P-30
Note :
Before using this
Automatic Power Pipe Cleaner Mini Rooter
carefully read through this INSTRUCTIONS MANUAL to ensure efficient,
safe operation. It is recommended that these INSTRUCTIONS be kept
readily available as an important reference when using this
Automatic Power
Pipe Cleaner Mini Rooter.
N
E
958
SI
1
C
O
P
WE
R
Page : # 4 M : 30
INSTRUCTION MANUAL OF AUTOMATIC POWER PIPE CLEANER MINI ROOTER
SAFE OPERATION
10.
Connect dust extraction equipment
If the tool is provided for the connection of dust extraction and collecting
equipment, ensure these are connected and properly used.
11.
Do not abuse the cord
never yank the cord to disconnect it from the socket. Keep the cord away from
heat, oil and sharp edges
12.
Secure work
Where possible use clamps or vice to hold the work. It is safer than using your
hand.
13.
Do not overreach
Keep proper footing and balance at all times.
14.
Maintain tools with care
Keep cutting tools sharp and clean for better and safer performance.
Follow instruction for lubricating and changing accessories.
Inspect tool cords periodically and if damaged have them have them repaired by
an authorized service facility.
Inspect extension cords periodically and replace if damaged.
15.
Disconnect tools
When not in use, before servicing and when changing accessories such as
blades, bit and cutters, disconnect tools from the power supply.
16
Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are
removed from the tool before turning it on.
17.
Avoid unintentional starting
Ensure switch is in "off" position when plugging in.
18.
Use outdoor extension leads
When the tool is used outdoors, use only extension cords intended for outdoor
use and so marked.
19.
Stay alert
Watch what you are doing, use common sense and do not operate the tool when
you are tired.
20.
Check damaged parts
Before further use of tool, it should be carefully checked to determine that if
would operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting and any other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by
an authorized service center unless otherwise indicated in this instruction
manual.
Have defective switches replaced by an authorized service center.
Do not use the tool if the switch does not turn it on and off.
