![background image](http://html1.mh-extra.com/html/i4home/i4h-pir-od1/i4h-pir-od1_quick-start-manual_3166761001.webp)
OUTDOOR PIR MOTION DETECTOR,
i4H-
PIR-OD1
INTRODUCTION
The
i4H-
PIR-OD1 Passive Infrared Detector is specially designed for providing perimeter protection. It detects the
intruder before entering a house, and offers the first line of defense to a property‟s boundary.
There are two separate sensors in the
i4H-
PIR-OD1, one detects upper area, and the other detects lower area. Only when
both sensors detect motion simultaneously, the PIR triggers alarm.
i4H-
PIR-OD1 is rainproof and can prevent from the false alarm caused by a pet up to 20 kg or 60 cm high.
INSTALLATION
1.
Refer to Fig. 1, loosen the screw on the PIR bottom, remove the front cover, and then insert two AA alkaline batteries.
2.
Enroll the ID for the PIR,
A)
Keep pressing the Clear/Enroll Button on
i4H-
LS-20 for over 3 seconds and then release it, the
i4H-
LS-20
would keep beeping and the all LEDs blink. This means the system is ready for enrolling device.
B)
Within 30 seconds, activate the PIR to transmit RF ID by placing a magnet closely to the reed sensor of the PIR,
refer to Fig. 8. If you hear 3 short beeps soon later then enrolling successes, otherwise you will hear one long
beep after 30 seconds that means enrolling fails, you have to repeat enrolling action.
Note: Avoid activating any other sensors during the 30 seconds Device Enroll period.
Remarks: In case you have to change the device‟s attribute, please do it on the cloud web directly, or refer to
HyperSecureLink software user guide to change it by computer.
3.
After the PIR power on, wait one minute for the sensors‟ warm-up.
4.
Before mounting the PIR, please refer to Fig 3, 4 &5 to choose proper location and height for the PIR. The PIR should
be mounted to detect majority of traffic flow across the detection pattern.
5.
Keep the PIR 1.9 m above the floor (refer to WALK TEST paragraph below and adjust it if necessary), fix the supplied
magnet for tamper detection, and then mount the base with four screws at the selected location, finally restore the top
cover the PIR. Make sure the distance between the PIR and the Base Unit is within RF transmission range or use a
repeater to extend the distance when necessary.
Important notice: It’s strongly recommended to mount the
i4H-
PIR-OD1 at the place where the sunlight doesn’t
shine it directly. Otherwise, the detection angle would become narrower. Additionally the lens would degrade by
sunlight and need to replace after 2or 3 years, depending on sunlight strength and exposed time.
Fig. 1
Click
Click
Press
Press
Fig. 2
Fig. 5
No Tilt
Tilt
Fig. 3
Fig.6
Magnet
Back Tamper
Magnet
Fig. 4