X1103
October 17, 2010
REMOVING THE FOOT-AND-CALF MASSAGER
1. Using two people, gently tip the chair onto its side (Fig.1).
2. Use the remote control to deploy the foot-and-calf massager until the connector box becomes
accessible (about 75% full deployment) (Fig.2).
3. Power off the chair, then unplug it.
4. Using a nail clipper or other suitable instrument, cut the zip ties that secure the connector box
to the chair frame (Fig.2).
5. Using a Phillips-head screwdriver, remove the four screws that secure the connector box cover,
then remove the cover (Fig.3).
6. Disconnect the connectors (Fig.4)
7. Using a nail clippers or any other suitable instrument, cut the zip-tie that secures the massager harness
to the frame (Fig.5).
Tools Required:
Phillips-head screwdriver, nail clippers or other instrument suitable for cutting zip ties, new zip ties.
NOTE:
SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
REPLACING THE FOOT-AND-CALF MASSAGER
HT-820/9200
It is imperative that Human Touch
®
products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 3
1
(Fig.1)
Zip ties
(Fig.2)
Connector box
(Fig.3)
Connectors
(Fig.4)
Zip-tie
(Fig.5)
