X1103
REPLACING THE BACKREST ACTUATOR
HT-5270
06/01/08
REMOVING THE BACKREST ACTUATOR
1 Use the remote to fully deploy the foot and calf massager.
2. Power off the chair and unplug it.
3. Using two people, tip the chair gently onto its right-hand side.
4. Facing the bottom of the chair, locate the connector junction box near the rear of the chair (fig.1), then remove the two screws that secure the box cover using a
Phillips-head screwdriver.
5. Remove the junction box cover, then disconnect the connectors inside (Fig.2).
Tools Required: needle-nosed pliers, pliers, Phillips-head screwdriver
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
(Fig.1)
CAUTION! You will need at least two people to complete this procedure, as the chair is very heavy.
Be sure you have enough people to safely tip the chair on its side, to prevent injury.
1
(Fig.2)
Connector junction box
To ensure that Human Touch
®
products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 3
