INSTALLATION INSTRUCTIONS
TRU-FIT
DOOR & PANEL
PARTS LIST
ITEM PART
DESCRIPTION
QTY
A ZSS-4506
Wall Jamb
1
B ZSS-4505
Hinge Jamb
1
C ZSS 4504
Longer Piece = Wall Channel
1
D ZSS 4504
Shorter Piece = Curb Channel
1
E CHG HGTW*
Glass Hinge
2
F CHG BTB
Back-to-Back Pull
1
G CMF Anchor
Plastic Anchors for Wall Jamb
6
H
#10 x 2”
Wall Jamb Screws
8
J ZV-935
Plastic Anchors for Channels
6
K
#8 x 2”
Wall and Curb Channel Screws
6
L #8 x 3/4”
Hinge Jamb to Wall Jamb Screws
5
M #10 x 3/4”
Heavy Glass Hinge to Post Screws 8
N ZV 969
Adjustable Post Cap
1
O
3/8” Clear Glass Door
1
P
3/8” Clear Glass Panel
1
Q SP-GSB125
Glass Blocks
6
R CHGP982
Bottom Sweep
1
S CHGP976
Angle Seal (Optional)
1
T CHGP972
Bulb Seal (Optional)
1
IMPORTANT NOTE:
Door should not be used for 72
hours in order to let silicone
cure properly.
When ordering repair parts, please provide the following information:
1. Model Number
2. Part Number
3. Part Description
4. Finish Color
Required Tools:
•
TWO PEOPLE
• Pencil
• Tape Measure
• Electric Drill
• Phillips Head Bit
• Scissors
• Level
• Flat Head Screwdriver
• Hammer
• Silicone
• Painters or Masking Tape
• 1/8” and either 3/16” or 1/4” Drill Bits*
* Select the proper drill bits for your installation conditions
(i.e. tile, porcelain, marble, etc)
* The three pre-drilled holes and screws
go on the inside of the enclosure.
** The two screws on the outside of the
enclosure are optional, but
recommended for structural integrity.
V5_21_26
* Standard hinge part number listed. Reference original order PO for replacement parts.
Hinge styles may vary.
