HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA
Phone: 800.848.4468 Fax: 858.552.0172 Website: www.hme.com
HME# 400G653
Rev D 5/28/14
ion AIO
All-In-One Headset
OPERATING INSTRUCTIONS
SETUP
Power On/Off
To turn the power on
Press and release the red power button on the headset
earpiece. A voice message in the earpiece will say
“Headset #, Battery Full/Half/Low” and the red power
light will come on and then begin blinking green and
change to steady green.
To turn the power off
Press and hold the power button for approximately
3 seconds. A voice message in the earpiece will say
“Headset off,” and the power light will go off.
Configure Headset
Start with power OFF and then press and hold any of the following button combinations while turning the
power ON. Immediately release all buttons after pressing the power button. Each of these settings has
an associated voice prompt. Listen to the voice prompt to confirm the setting.
Hands Free (HF) on/off
–
Press and hold
B
and the
UP arrow
“
Λ
” while you press the power button to turn
the headset on in the HF mode. With the power off,
press and hold
B
and the DOWN arrow
“
V
” while you
press the power button to turn off the HF mode.
Auto HF (AHF)
–
Press and hold
A1
or
A2
and the
UP arrow
“
Λ
” while you press the power button to turn
the headset on in the Auto HF mode. When you turn
the unit off, the AHF mode will not be saved.
“B” Channel HF (BHF) –
Press and hold
B
and
A2
while you press the power button to turn the headset
on in the BHF mode. This will keep the
B
channel
open to allow hands-free communication with other
crew members. If a customer arrives, B-channel
communication will automatically be interrupted to
allow communication with the customer on A1 or A2.
Language selection
–
To change between English and another language, press and hold
A1
and the
DOWN arrow
“
V
” while you press the power button to turn the headset on. Doing this again changes
back to the first language.
Play status
–
Press
A2
and the DOWN arrow
“
V
” while you press the power button to turn the headset on.
An example of the status you will hear is: “Headset #, Battery Full/Half/Low, English/Espanol, Hands-free
A
on/off (or Hands-free
B
on/off)
, firmware version #.”
If you have any problems with your All-In-One Headset:
In the USA
, call or Fax HME Customer Support at the numbers shown below.
Outside the USA
, call your local HME
®
representative for help.
Figure 1. All-In-One Headset
power button and light
Figure 2. Headset buttons
A2
Λ
A1
V
B
Power
button
Power
light
