INSTALLATION
1. Fan may be securely mounted upright in wall, suspended
from ceiling, or hinged from wall or post.
In Wall:
Refer to Framing Diagram on reverse side.
Suspended:
Install 3/8" bolts with nuts, or 3/8" eye
screws in ceiling at desired mounting location. Hang fan
with chain and S-hooks or with winch, pulleys, and cable.
2. Fan is provided with wire guards for your protection.
National safety codes require that guards be installed
if fan is installed within 7 feet of floor or in reach of
personnel or livestock.
FAILURE TO GUARD MOVING PARTS MAY RESULT
IN SERIOUS INJURY OR DEATH.
3. Unit is now ready for operation.
IMPORTANT: INSPECT FAN FOR ANY OBJECT THAT
MAY OBSTRUCT BLADE ROTATION.
Disconnect power source before installing
or servicing fan. Failure to disconnect power
source can result in property damage, serious
injury, or death.
CAUTION
1. Inspect fan for damage in transit. Check for loose,
missing, or damaged parts.
BEFORE INSTALLING FAN
MAINTENANCE
1. Read WARNING statements before proceeding.
2. Blades, motor and wire guards should be
cleaned periodically to decrease vibration and
ensure maximum fan life.
DO NOT SPRAY
MOTOR WITH WATER OR CLEANING
FLUIDS
- remove dirt with a dry brush or
compressed air.
3. Fan performance may be greatly reduced by
damaged or dirty shutter. Clean and inspect
shutter periodically to ensure maximum fan
performance.
WARRANTY
Your Econo Flow fan has been manufactured with the
finest materials and components available and is backed
by a one year warranty against electrical and mechanical
defects in material and workmanship. If this fan fails to
operate during this period, return it prepaid to place of
purchase for repair or replacement without charge at the
manufacturer's option.
Damage by accident or abuse is not covered by this
warranty.
48" Econo Flow Direct Drive Fans must always have
shutters installed to prevent reverse blade rotation.
These fans are not designed to be used in outdoor or
open sidewall buildings.
Hired-Hand Manufacturing, Inc. makes no guarantees
regarding the proper operation of this appliance when
these conditions are not met.
This warranty gives you specific legal rights and you may
have other rights that vary from state to state.
WARNING
HAZARDOUS ROTATING FAN BLADE
!
Do not operate fan until you are completely
familiar with its operation.
READ ALL
INSTRUCTIONS PRIOR TO INSTALLATION.
VOLTAGE
230 VAC - 60Hz
CURRENT
4.4 Amps (Maximum)
(See Reverse Side for Parts List)
THIS FAN MAY START AT ANY TIME
!
WARNING
When this fan is used in a life support ventilation system
where failure could result in loss or injury, the user should
provide adequate backup ventilation or accept the risk of
such loss or injury.
WARNING
!
HIRED-HAND, INC.
1733 County Road 68 Bremen, AL 35033 PHONE 256-287-1000 FAX 256-287-2000
Manual Part No. 4801-0107 rev 2-03 Page 1 of 2
