STUDIO1 NZAust v1.8 MW
Page
1
of
3
STUDIO 1 LADDER TOWEL WARMER
For Warm Fluffy Towels
Operation
Your STUDIO 1 Towel Warmer uses only minimal electrical power - about the same as an average light bulb. It will
take approximately 20-30 minutes to reach maximum operating temperature. STUDIO 1 Towel warmers are designed
for continuous operation. NOTE: The temperature of your towel warmer will vary with the ambient temperature of your
room. A towel warmer is designed to warm and assist the drying of towels and will normally operate at a temperature
that is too hot for the warmer to be grasped for an extended time.
Locating Instructions
Detailed installation instructions are provided on the reverse side. The STUDIO 1 Ladder Towel Warmer should be
fixed through the wall cladding directly to studs or other suitable anchor material. The towel warmer should be located
in compliance with the AS/NZS 60335 Standard and should not in any circumstances be located in the direct path of a
water source (tap or shower etc). STUDIO 1 towel warmers have an IP45 rating offering you the greatest flexibility to
safely locate the towel warmer in bathrooms or shower rooms in
Zone 1-3
. All other electrical fittings must also be
compliant with the zone within which the warmer is being installed.
Electrical Installation
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical supply, plug & switch
location, and product location will comply with your local regulations.
New Zealand electrical wiring requirements stipulate that this appliance must be wired by a registered electrician in
accordance with current electrical wiring regulations. This appliance must be fitted with an air gap phase isolation
switch which isolates the phase & neutral in accordance with local wiring regulations.
This product must be used in
conjunction with a hard wired switch
. For complete temperature control a wall mounted dimmer switch (with “off”
position) is recommended.
Concealed Wiring Kit
A concealed wiring adapter kit is included with this product. If you have access to the wall cavity the kit allows you to
conceal the electrical flex for a more streamlined and visually appealing installation.
Care and Cleaning
The polished stainless steel finish of your Towel Warmer is hard wearing and easily maintained. Clean regularly with a
soft cloth and non-abrasive cleaning agent.
Guarantee
This product is guaranteed against defects due to faulty workmanship or materials for 5 years from date of purchase.
In the event of a defect in the product, it should be returned with the sales receipt to the retailer from whom it was
purchased. Under the guarantee the defective article will be repaired or replaced at Heirloom’s option – free of charge.
Costs of disconnection, reconnection, and freight are the responsibility of the owner, as is any damage arising in transit
to and from servicing.
This guarantee does not cover:
a.
Any damage to the product caused by misuse, neglect, accident, or in violation of the manufacturer’s
instructions, or
b.
Any damage, loss or injury arising as a consequence of the use of the product.
Contact Us
We welcome your feedback on our products. You can view our full range of towel warmers on our website and send us
your comments about this product to
Heirloom International Limited,
P O Box 204 235,
Manukau 2161,
New Zealand. www.heirloom.co.nz
