PROJECTOR LIFT MODEL . SI-100
INSTALLATION MANUAL
Thank you for purchasing the new Harkness Screens SI-100 Projector Lift.
The SI-100 is supplied with a set of components and accessories that make it suitable for installation
for the majority of standard AV applications, but note must be made of the restrictions that apply to the
weight capability of this unit and not exceeded.
Before installing the projector lift, please read the following instructions carefully:
•
The projector lift must be used INDOORS ONLY.
•
Please confirm that your projected image width will fit your screen from your
proposed mounting location prior to installation.
•
Incorrect use of the lift, including exceeding the maximum lifting weight, would be
dangerous. The manufacturer does not take responsibility for any damage to property or
personal injury if the lift is used outside of recommended specifications.
This product uses a 230V AC Motor. DO NOT attempt to service the motor.
Incorrect servicing could lead to risk of electric shock. For any repairing, please contact us
directly or via the Harkness dealer you purchased the unit from.
SUPPLIED EQUIPMENT LIST :
When you open the packaging, please CHECK that it contains ALL the components below :
A) 1 MECHANIC PROJECTOR LIFT SUPPLIED WITH A PLASTIC CABLE CHANNEL AND MOTOR
WITH A 3 METER CABLE WITH FOUR ELECTRIC WIRES ( UP, DOWN, NEUTRAL AND EARTH)
B) 4 “L” FORM ALUMINIUM BRACKETS FOR CEILING MOUNTING
C) ON/OFF SWITCH UNIT
D) INSTRUCTIONS FOR ELECTRICAL CONNECTIONS BETWEEN MOTOR AND SWITCHER
E) 4 THREADED BARS M6 L. 25 CM AND 2 MOUNTING PLATES FOR THE FALSE CEILING PLATE.
F) 8 HEX HEAD SCREWS 6x16 MM.
G)
16 NUTS M6 FOR MOUNTING THE THREADED BARS TO THE MOUNTING PLATES AND TO THE LIFT
