CUS-012-0013-03
Page 1 of 1
Morning Startup
Elemendt
®
1000 Electric Rotisserie
1.
Ensure that the rotisserie has been
properly cleaned from the previous
night.
2.
If applicable, install the drip trays
inside the rotisserie by resting them on
the support pins.
3.
If applicable, install the drive
assembly into the rotisserie. Use the
green button to rotate the drive until the
groove on the right side is horizontal.
4.
Insert the right end first by placing
the pin on the drive assembly into the
groove of the rotator.
5.
Then, lower the left end of the drive
assembly into its bracket.
6.
Place grease reservoir (or bucket)
under the drain to collect the grease.
7.
Ensure that there is no water in
the bottom of the rotisserie pan and
open the drain valve.
8.
To preheat the oven, set the
thermostat to # 7 and the timer to 15
minutes. Pull the red button to start
preheating the rotisserie.
9.
The alarm will sound after
approximately 15 minutes indicating that
the rotisserie is ready to be loaded.
NOTE:
If oven has optional end of
cook light, this will also flash indicating
that the rotisserie is ready.
15
7
1
2
