Graco PJR REACTOR E-8p Setup Overview Download

Page: 1 / 6

For spraying 1:1 mix ratio formulated no-heat polyurethane foams and dispensing 1:1 mix

ratio polyurea joint-fill materials. For professional use only.

Not approved for use in European explosive atmosphere locations.

2000 psi (14 MPa, 138 bar) Maximum Working Pressure

See page 3 for a list of models.

Important Safety Instructions

Read all warnings and instructions in this

manual before using this equipment.

Save these instructions.

Setup & Start Up

Overview

VEE AIR ONE-SP Air-Purge Gun

2-Part Adhesive Spray Applicator

Portable Plural Component Sprayer

Summary of Contents for PJR REACTOR E-8p

Page 1: ... European explosive atmosphere locations 2000 psi 14 MPa 138 bar Maximum Working Pressure See page 3 for a list of models Important Safety Instructions Read all warnings and instructions in this manual before using this equipment Save these instructions EN Setup Start Up Overview VEE AIR ONE SP Air Purge Gun 2 Part Adhesive Spray Applicator Portable Plural Component Sprayer ...

Page 2: ...ves E Control Panel F Electric Motor and Drive Housings G Hose Bundle H Spray Guns J Recirculation Outlet L Outlet Hose Connections M Power Cord P Fluid Inlet FIG 1 Component Identification JUST THE TIP THAT S ALL YOU NEED ADD JUST THE TIP TO YOUR V MANIFOLD TO ENABLE AIR PURGE SPLATTER FULL SPRAY AND STATIC BEAD SPRAY CAPABILITIES IN 1 GUN ...

Page 6: ...re Fill wet cups through the slots in the plate or remove a screw and swing the plate to the side The pump rod and connecting rod move during operation Moving parts can cause serious injury such as pinching or amputation Keep hands and fingers away from the wet cup during operation Shut off power before filling the wet cup FIG 4 Fill Wet Cup Slots TI17124a ...