Step 3: Three Button (1 door only)
Relocate the jumper to the last two pins (on the
right hand side) as per the above diagram. The
jumper is the small, black sleeve that slides over
the key shunt.
Step 3: Single Button (1-3 doors)
Relocate the jumper to the first two pins (on the
left hand side) as per the above diagram. The
jumper is the small, black sleeve that slides over
the key shunt.
Glidermatic GTS+ Optima
Handset Key Settings
www.gliderol.com.au
The following instructions demonstrate how to program or change the key settings on your Gliderol
handset, allowing you to select the specific button that operates your door. This procedure will assist
in reprogramming your handset from three-button Open/Stop/Close operation to single-button
operation. It will also assist in reprogramming your handset to operate multiple doors.
Step 1:
Carefully remove the light cover by pulling down
on the tab near the front of the unit.
Note:
The light cover is connected to the units circuit
board. Whilst the cover can be unplugged to program
your handsets, it must be reconnected to the same two-pin
position when completed.
COVER
TAB
Step 2:
Locate the key shunt on the main control board
(behind the ‘LIMIT’ button). These are labelled
1KEY/3KEY and correspond to the buttons on
your remote.
KEY
SHUNTS
1KEY
3KEY
KEY
3
KEY
2
KEY
1
Note: Changing the key setting on your operator will update all programmed handsets.
KEY
3
(CLOSE)
KEY
2
(OPEN)
KEY
1
(STOP)
