-1-
D-TECT X REPEATER
GJD 397 Repeater
Package Contents
Package Contains:
•
1 x D-TECT X Repeater & 1A PSU in IP65
Housing
•
1 x Installation Manual
Introduction
The D-Tect X Repeater can be used to extend the
range of a D-Tect X detector, or to boost signal in a poor
reception area.
D-Tect X Repeater
The D-Tect X Repeater must be placed within 500
metres line of sight between the D-Tect X detector(s)
and D-Tect X Receiver(s). The unit will repeat all signals
from D-Tect X detectors within range and as such does
not require any programming to function.
Specifications
Range
500m (line of sight)
Tamper Switches
Front and rear tamper switch-
es: case open and removal
from wall
Wireless Frequency
868MHz
Current
23mA (12V nominal)
Operating Temperature
-10 to +50 Centigrade,
Conformal coated electronics
for increased stability
Housing
High impact, flame retardant,
UV stabilised Polycarbonate
Protection Rating
IP55
Dimensions
W210mm x H180m x D79m
Weight
750grams NET, 880grams
GROSS
Power Supply Module
The GJD Power Supply Module provides a 12 VDC
output from a 230 VAC input that enables the D-Tect X
Repeater to be conveniently installed with easy access
to a mains supply.
Installation
•
The Power Supply Module requires a 230 VAC-
supply on the LIVE input and a neutral on the N
connection.
•
An EARTH connection is also provided for the
termination of the earth conductor. Ensure this
connection is securely made.
•
Connect the positive and negative terminals of the
12 VDC output to the corresponding inputs of the
D-Tect X Repeater.
IMPORTANT SAFETY REQUIREMENTS
•
The Power Supply Module MUST be installed and
maintained by suitably qualified engineers and the
installation MUST comply with all relevant code of
practice and regulations.
•
All mains supplies to the module MUST be via a
Residual Current Device (RDC) and an overload
protection device.
•
All mains supplies to the module MUST be
disconnected before removing the cover.
Specifications
Mains Supply Input
230 VAC, 50 Hz
12 VDC Output
12 VDC, 1A
5 VDC Output
5 VDC, 0.1A
Operating Temperature
-10 - +50 degrees centigrade
