PART
QUANTITY
Trim Frame
1
Bottom Duct
1
Side Duct
1
1” Screws
6
(4 required, 2 extra)
1/2” Screws
15
(11 required, 4 extra)
Anti-Tip Bracket
1
Bottom Bracket
1
Upper Duct
1
Template
1
PARTS INCLUDED
Questions? Call GE Answer Center at 800.626.2000
or
Visit our Website at:
www.GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
.
Installation
Built-In Trim Kits
Instructions
JX1827 and JX1830
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
BEFORE YOU BEGIN
•
Unplug the microwave oven before attempting
installation of this kit.
•
Skill level
– Installation of this appliance requires basic
mechanical and electrical skills.
•
Completion time
– 1-3 hours
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty.
•
This kit is UL listed for installation alone or over any
General Electric/Hotpoint/RCA single electric wall
oven.
TOOLS YOU WILL NEED
Phillips screwdriver
Pencil
Tape measure
Awl or punch
Drill with
7
⁄
64
″
bit or #35
1
FOR YOUR SAFETY:
WARNING –
Before beginning the
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.
