19058 Coral Springs Outdoor Water Feature
www.gardman.co.uk
Please read the assembly instructions and separate pump instructions carefully prior to installation.
Assembly Instructions
•
Unpack all the water feature components from the packaging and lie on a flat surface.
•
Remove the top part (
1
) of the feature and connect the rubber tube (
3
) that is located on the
underside in to the opening on the pump (
2
). Lay the pump inside on the base of the feature (
4
).
Make sure the tube is properly connected and is not kinked.
•
The pump flow can be adjusted by moving the dial (
5
) which is located on the inlet of the pump.
•
Connect the two cables (
6
) & (
7
) and screw over the plastic collar (
8
) until secure.
•
Position the cable through the cable slot located on the top part of the water feature under the head
piece. Plug the 2 pin connector (
9
) in to the plug/transformer (
10
). Do not insert the plug in to the
mains at this time.
•
Fill the reservoir in the base with water up to halfway from the top.
