![background image](http://html1.mh-extra.com/html/rab-lighting/wpled10/wpled10_installation-instructions_3124187001.webp)
10W LED WALLPACK INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT.
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable
parts inside.
Thank you for buying RAB lighting
fixtures. Our goal is to design the
best quality products to get the job
done right. We’d like to hear your
comments. Call the Marketing
Department at 888-RAB-1000, or
email: [email protected]
JUNCTION bOx MOUNT fOR
CONDUIT
For use on retrofit applications that make conduit
necessary.
Loosen and remove (3)
Lens Screws
. Remove
Door
.
Loosen and remove (2)
Housing Screws
. Remove
Housing
from
Back Box
. Keep
Gasket
intact for
re-assembly.
Secure
Back Box
to the mounting surface using
hardware appropriate for that mounting surface.
Wire the fixture using UL approved wire connectors
and according to NEC and local codes. Apply
sealant to all unused conduit entry points.
Place
Gasket
between
Back Box
and
Housing
.
Re-mount
Housing
to
Back Box
. Check
Gasket
seal all around the
Back Box
.
Re-mount
Door
to
Housing
. Tighten (3)
Lens
Screws.
Check Door gasket seal.
Fixture can be mounted upside down in dry and
damp locations only.
1.
2.
3.
4.
5.
6.
7.
Lens
Screws
SURfACE MOUNT fOR
RECESSED bOx
For use with recessed junction box and wiring.
Use supplied crossbar. Mount
Crossbar
to recessed
junction box with (2) screws.
Place
Gasket
on back of the fixture. Gasket should
create seal against mounting surface.
Wire fixture to supply wires in recessed box according
to wiring section.
Use 1/4 x 20 stainless steel
Mounting Screw
to
attach fixture to Crossbar. Tighten
Mounting Screw
.
Cover screw with
Cap,
provided.
Fixture can be mounted upside down in dry and damp
locations only.
1.
2.
3.
4.
5.
6.
WPLED10
Junction Box
WPLED10S
Surface Mount
Crossbar
Gasket
Mounting
Screw
Cap
Back Box
Gasket
Housing
Door
Housing
Screws
Recessed
Junction
Box