![background image](http://html1.mh-extra.com/html/gamco/bcs-1/bcs-1_installation-and-operation-instructions_3309371001.webp)
Your unit can be installed to meet ADA regulations when and where applicable. Refer to Federal Register, Volume
56, No 144 28 CFR Part 36.
You are responsible for the safe operation of this unit.
INSTALLATION AND OPERATION INSTRUCTIONS
GAMCO WALL-MOUNTED BCS-1 AND BCS-2
Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the Gamco Baby
Changing Station. Gamco Commercial Restroom Accessories will not be responsible if the station is not
installed properly
Gamco Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load.
The maximum recommended
total weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight may
cause a hazardous or unstable condition to exist.
Using Restraint System
To fasten the waist restraint strap, place strap around child’s midsection, and push spring tabs into buckle
until both spring tabs lock in place with an audible “click”. Straps can be adjusted to make strap tighter or
looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
–
Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit at both
ends.
– Provides a clean, convenient place for customers to attend to their children.
OPERATING INSTRUCTIONS
ASTM F 2285-04
WARNING
:
Never leave child unattended.
WARNING
: Avoid serious injury from
falling or sliding out. Always use restraint system.
WARNING
: Designed for Infants Only.
Age up to 3.5 years and weighing less than 50
lbs. Keep one hand on the child at all times.
Parcels or accessory items, or both, placed on
the unit may cause the unit to become unstable.
EN 12221:2008
WARNING: Do not leave the child unattended.
All assembly fittings shall always be correctly tightened and
checked regularly.
Be aware of the risk of open fire and other sources of strong heat,
such as electric bar fires, gas fires, etc. in the near vicinity of the
changing unit.
The changing unit is intended up to a maximum weight of 15 kg.
Do not use changing unit if any parts are broken or missing. A
changing pad is not required for this product.
Additional or replacement parts shall only be obtained from the
manfacturer or distributor.
Unit should be cleaned once or more daily with a clean nylon brush
and spray disinfectant.
MATERIALS SUPPLIED:
TOOLS WHICH MAY BE NEEDED FOR INSTALLATION:
Measuring Tape
Gloves
Level
Stud finder
Pencil
Drill
Phillips screwdriver
7/32" Drill Bit. (masonry)
1/8" Drill Bit. (regular)
1/2" Drill Bit. (reg & masonry)
(4) 1/4" x 3" Panhead wood screws
(4) 1/4" Flat washers