Flexcharge
USA
PROGRAMMABLE TIMER
7 Day, 8 Event Pairs, 16 Amp Resistive, 8 Amp Inductive, 12 Volt
OVERVIEW
Now you can have full control of lights, pumps, cameras, etc. with the accuracy of a Quartz clock.
Perfect for signs, yard lights, etc. The light can be turned ON and OFF at specific times of day and many
times a day if needed. When used in conjunction with the Flexcharge NC12L12 or Night Watchman
Dusk to Dawn controls, you can delay the evening turn ON until it is dark but still have an exact turn OFF
time. This will automatically compensate for changing sunset times. An internal replaceable Lithium
battery will retain your programming in the event of a system power failure. The basic system is capable
of controlling loads up to 16 amps at 12 volts and can easily drive an external relay to load capacities up
to 100 amps.
INSTRUCTIONS
Follow the wiring diagram to connect the wires to your 12 volt system. The timer must operate from 12
volts AC or DC but the switch will control any voltage up to 250V. The BAT+ and BAT- terminals must
be connected to a 12 volt source to switch the load ON and OFF.
You must supply power to the
Common ( C ) terminal for the load to obtain power.
This can be any voltage up to 250 volts to meet
your load requirements. For example if your load is to operate from the same power source as the timer
clock, connect the ( C ) terminal to the battery positive terminal.
SETTING TIME
Set the clock to your local time and the day of the week.
1) Press and hold the
CLOCK
button.
2) Set the day of the Week by pressing the
DAY
key until the correct day appears.
3)
Set
the
HOUR
by pressing the
HOUR
key until proper hour appears. (24 hour time)
4)
Set
MINUTE
by pressing the
MIN
key until the proper minute appears
When the time and day is set, release the
CLOCK
key
PROGRAMMING:
It is not necessary to use all 8 event pairs but you will need to set both one
ON
time
and one
OFF
time for each event.
1) Pressing the
TIMER
key will enter the Program mode. Pressing the
TIMER
key will scroll
through the events. Stop on the event you want to set. There are 8 events and an
ON
and
OFF
time for
each event. Only set the events you need. All others can remain blank.
2)
Press
DAY
key to select the day or group of days. Press the
HOUR
key to set the hour and the
MIN
key to set the minute. To clear the event, press the
DAY
key then press and hold the
TIMER
key
until the setting clears. Always set an
OFF
time for each
ON
time. It is possible to have one
OFF
event
for several
ON
events. For example, if you have a light that comes on at different times each day but is to
be
OFF
at the same time every day. One
OFF
event is all that is needed as long as it covers all of the
ON
days.
When the programming is complete, press the
CLOCK
key.
The
MANUAL
key will select
ON
,
AUTO
, and
OFF
. For Automatic operation it must be set to
AUTO
.
You can manually turn the load
ON
and
OFF
by selecting
ON
or
OFF
. Watch the ___ cursor along the
bottom edge of the display window and stop it over the function you want.
All programming and time can be reset to N
ew
settings by pushing the
RESET
button with a pencil or
pen.
Use caution, all programming will be lost when this button is pushed
Units manufactured after 10/01/00. After several years the battery may need replacement, contact the manufacture or your
dealer for further instructions.
Tmrins.doc
www.flexcharge.com
Содержание PROGRAMMABLE TIMER
Страница 2: ......
