Installing the Interface
REV 281
117
Follow the instructions below to install the FT-RC-RN kit.
Turn on the car ignition and the radio (Media NAV). Then, plug the device to the vehicle’s OBD connection (usually found inside
the glove compartment).
Once you plug in the device to the OBD connection, wait for the device to program the rear camera and reset the radio. After the
radio has been reset, you can unplug the device and hand it over to the costumer, in case he needs to enable the rear camera
once again.
Important Notice
When you plug in the device for the first time, the device will program the rear camera and save the vehicle’s chassis number. If
you plug the device again, it will deprogram the rear camera and reset the device memory, which will make it ready for installing
in another vehicle. Therefore, every time you remove the device from a vehicle, you will need to disable the rear camera; other-
wise it will not be possible to install this device on a new vehicle.
OBD Connection
Plug in to the vehicle’s OBD connection
to program the rear camera.
The OBD connection generally can be found inside
the glove compartment or underneath the dashboard,
close to the gear and brake pedals.
Signaling LED
Blinking Blue – Signals the rear camera has been programmed
Blinking Red – Signals the rear camera has been deprogrammed
On Purple – Signals the device has already been used on another vehicle
Installation Manual
FT-RC-RN
For your safety and comfort, read this manual carefully.
Scan this QR code to see which
vehicles are compatible.
+55 0800 603 2330 or +55 62 3241 4600
[email protected]
www.faaftech.com.br
Available from Monday to Friday, from 8 a.m. to 6 p.m. Brasilia time
TECHNICAL SUPPORT
Follow us on social media
