Instructions for Assembly – EZ HANG Wooden Love Seat Series
Regarding any questions about our products please contact your sales rep. or visit our
website.
***
IMPORTANT MAINTENANCE INFORMATION***
The wood on your love seat wood series is covered with a protective coat
of polyurethane. We recommend annually reapplying polyurethane or
any other protective varnish of your choice.
Eyebolt Installation
Locate ceiling joist (by Stud Finder or tapping and verifying with a small nail.) Be
sure to locate exact center
.
Using a 3/16” (3mm) wood drill bit, drill a hole
(approx. 4” (10CM) deep) perpendicular to the ceiling. Screw in the two supplied
eye lags until all threads have disappeared into the joist. Make certain the
distance apart is approximately 49”. Do not loosen or adjust once in place.
Important:
Hole must be directly in the center of the stud for full weight bearing
capacity. Spinning or swinging could loosen and compromise the eyebolt strength.
To adjust the pitch of the Love Seat simply adjust the knots in the back of the
Love Seat.
Place the square spreader bar with “S” hooks by hanging them on the chain
above the “O Rings” at a comfortable height. Make sure the two center eyebolts
are pointing downward as these can be used to attach footrests.
The chair should now be at a comfortable sitting height. Make sure that all the
ropes are secure, knots are properly tied, and that the eye lags are properly
installed. Also make sure all the bolts are tightened. Sit on the chair gently as it
will stretch at first. You can always take up the slack at a later time.
Important Reminders:
✓
▪
The EZ Hang Loveseat is NOT a swing. We highly recommend using only
