Cable Cubby • Setup Guide
1
This guide provides instructions for an experienced installer to
install and connect the Extron Cable Cubby
®
300, 600, and 800.
The Cable Cubby units are furniture-mounted enclosures for cable access,
connections, and AC power. Cables that are not in use can be stored
out of the way while remaining connected to the presentation system.
Planning
Determine the best location for the enclosure. Before making any cuts:
c
Ensure that the location where the Cable Cubby is to be installed is
convenient for as many users as possible.
c
Ensure that the edge on which the lid opens is oriented correctly.
c
Ensure that there is ample space under the table for cables.
c
Ensure that the correct template or dimensions are used.
Decide on the method for cutting the hole in the table.
c
Hand router and template
c
CNC wood router
c
Jigsaw and paper template
Before starting the installation, check with local and state regulations:
c
Ensure that the planned installation complies with building and
electrical codes.
c
Ensure that the planned installation complies with the Americans with Disabilities Act or other accessibility requirements.
Tools and Equipment Required for Installation
Safety Glasses
Phillips Screw Driver
Tape Measure
Vacuum Cleaner
1/4" Hex Nut Driver
Marking Pen
Square
Included Parts
Cable Cubby Enclosure (1)
300S
300C
800
600
Zip Ties
Tweeker (1)
Screw Clamps (2)
AC Power Module
(quantity is optional,
depending on model)
#4−40 Screws & Nuts
Model
2 Pos
AAP Shelf Brackets
3 Pos
Grommet and
hole plug kit
CC 300 US/Int’l
CC 600 US/Int’l
CC 800 US/Int’l
0/2
0/2
0/0
2/0
4/2
0/2
4 Pos
0/0
0/0
4/2
L
L-M
Pass through AAPs*
R-M
R
1/1
2/3
2/3
0/0
2/2
3/3
1/0
2/1
3/2
2/1
2/1
2/1
* L = left, L-M = left-middle, R-M = right middle, R = right
Cable Cubby 600
