Solar Lighthouse "Roter Sand"
Art. No.: 27672
The solar light is a green and environmentally-friendly product. The light is
powered by solar energy through sun. The solar panel converts sunlight into
electric energy and then charges built-in 300 mAh AA Ni-MH rechargeable battery
during the day. A light sensor turns on the light automatically at night.
The light should be installed in a place where the best sunlight can be located
and the surface of the solar panel should be placed in the best direction in ord er
to receive the maximum amount of the sunlight. The light source is a super
bright LED.
FOR FIRST TIME USE
REMOVE ALL PLASTIC FILM ON SOLAR PANELS BEFORE USING.
NOTE: If the light does not turn on, remove battery, wipe both ends with a clean, dry cloth and
replace battery. THE SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 24
HOURS WITH THE SWITCH “ ON ” position. THIS ALLOWS THE RECHARGEABLE
BATTERY TO REACH MAXIMUM CAPACITY. If the lamp does not light after charging, make
sure the switch is pushed i
n "ON” position. Check the battery to ensure that it is making
secure contact with the terminal.
A
.
Solar Panel B. LED C. Main Body
ASSEMBLY INSTRUCTIONS
Assemble as shown in Diagram a, put the lock on the Body (part B) into the slot on the
bottom of the Solar Panel Unit (part A), and then clockwise twist the Solar Panel Unit
(part A) to tighten.
REPLACING THE BATTERY
Twist the Solar Panel Unit (part A) anticlockwise from the Body (part B) and pull up the
battery compartment cover.
Replace the old battery with new battery in correct polarity.
Replace the upper part tightly
GB
