ENFORCER Proximity Card Reader
12
SECO-LARM U.S.A., Inc.
WARNING
:
Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause a dangerous electric shock, damage the device,
and void the warranty. Do not open the case of this device, as there are no field-serviceable components inside.
WARRANTY
:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a period of one (1) year
from the date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned,
transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal
usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than
defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at SECO-LARM’s option. In no event
shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE
:
The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is one of continual
development and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for
misprints or typographical errors.
Copyright © 2014 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of
SECO-LARM.
Troubleshooting:
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999
PICGN1
MiPR-112S-A_1406.docx
Website: www.seco-larm.com
E-mail: [email protected]
The LED does not light
•
Check the power connection
•
Check the power supply
The relay does not activate
•
Make sure you are using a valid user card
•
Make sure the relay is not in toggle mode
•
Make sure the correct relay output is being used
(either N.O. or N.C.)
The relay time is too short
•
Set a longer door-release time
Egress button not working
•
Make sure you are using a N.O. switch
•
Double-check the door-release time
•
Double-check the relay toggle mode
Also Available from
:
Electromagnetic Locks
Electric Door Strikes
Request-to-Exit Plates
80, 300, 600, and 1,200-lb
Holding force available
Different sizes and
applications available
Different sizes and
button types available
•
Stand-alone operation
•
Sealed and weatherproof (IP67)
•
Tri-color LED status bar
•
Up to 100 user cards
•
Up to 5 master cards
•
10 Cards included
PR-112S-A
Proximity Card Reader
Manual
