Endura Flap Wall Mount Pet Door
Congratulations on your purchase of the finest pet
door made, featuring the exclusive Endura Flap.
TM
Installation Instructions
Instructions are for both the single and double flap models.
Please read instructions thoroughly before beginning installation.
Degree of difficulty:
Easy
Moderate
Difficult
For replacement fflaps and parts or other
quality pet products, visit
peterspetsupplies.com
PARTS LIST:
4 Threaded Rods
4 Open Barrel Nuts
1 Hex Nut
1 Tube of Silicone
4 Tunnel Pieces
2 Foam Weatherstrips
8 Hole Plugs
1 Jigsaw Blade
1 Template
1 4
” Screw (used to
guide Threaded Rods)
1
STEP ONE
TOOLS REQUIRED:
Jigsaw
•
Level
•
Pencil
Tape
•
Nail or Awl
Rubber Mallet
Drill with extra
long 3/8
” Bit
Philips Head
Screwdriver (#2)
Measuring Tape
3
STEP THREE
For replacement flaps
and parts or other quality
pet door products, visit
PetProSupplyCo.com
Tape the provided template
onto the wall in the desired
location. Use a level to level
the top edge of the template.
The top edge of the cut out
should be 1-1/4
” (or more)
above the dog
’s withers
(shoulders) for the single flap,
and 2
” for the double flap.
IMPORTANT: Be careful to
avoid wall studs, electric
wires, or pipes.
2
STEP TWO
Mark the centers of the four
holes using an awl or nail.
Remove the template. Drill
four 3/8
“ holes through
the interior and exterior walls.
Tip:
The drill bit needs
to be long enough to go
through both interior and
exterior walls (6
”–12”).
The holes must be drilled
very straight and level.
Professional help is
recommended.
Draw lines connecting the
outside part of the holes.
Cut out the opening along
the lines.
4
STEP FOUR
Install the weatherstip
into the groove in
both the interior
and exterior frame.
Tip:
Install the weatherstripping
with the gap at the bottom.
Endura Flap
TM
|
U.S. Pat. No. 7,814,956
|
Pat. Pending
These images are representative. Appearance of your pet door may vary slightly depending on model.
Endura Flap
TM
|
U.S. Pat. No. 7,814,956
|
Pat. Pending
