V+
General INFORMATION:
The B157 EMG Pickup Buss provides a convenient way to install EMG Pickups without soldering. The buss includes an input/output section for
the pickup signals. A V+ Supply buss for supplying the pickups and accessories with battery power. A two section terminal block and additional
header for connecting the selection switch and any ground wires. In addition, solder pads are provided for both the Input/Output section and the
V+ Supply buss so older EMG Pickups without connectors can be easily soldered to both busses.
The Pickup Buss can also be used for passive EMG-HZ Pickups.
1) Pickup Input/Output Buss
2) Switch Block
Pickup send and return from the selection switch (GREEN)
3) V+ Supply Buss
2a) Switch Header (Alternate switch send and return)
4) Ground Block (BLACK)
0230-0113E
© 2009 Copyright EMG INC. All Rights Reserved.
PO BOX 4394
SANTA ROSA, CA
95402 USA
P (707) 525-9941
F (707) 575-7046
EMGPICKUPS.COM
INSTALLATION INFORMATION
EMG MODEL:
B157 EMG PICKUP BUSS FOR 2 PICKUPS
USING A SELECTION SWITCH
(ACTIVE OR PASSIVE EMG PICKUPS)
BRIDGE PICKUP INPUT (POSITION 1)
NECK PICKUP INPUT (POSITION 2)
OUTPUT (POSITION 3)
NECK PICKUP
BRIDGE PICKUP
The EMG Pickup Buss has 4 main sections.
All 4 sections are typically used, so read the
instructions and use the diagrams for assistance.
Section 1) Pickup Input/Output Buss:
This is the 6 pin header with the
BLACK
shroud.
Diagram #1 (Master Volume / Master Tone Controls)
This diagram shows the pickups plugged directly into the Input/Output
buss (Positions 1 and 2). Use diagram #1 if your guitar has only a
Master Volume, or only a Master Volume and Master Tone.
The output of the buss (Position 3) will go to the Master Volume Control,
then to the tone control, and finally to the output jack.
NK VOLUME
FROM NECK PICKUP
FROM BRIDGE PICKUP
BR VOLUME
BRIDGE PICKUP IN AFTER VOLUME
NECK PICKUP IN AFTER VOLUME
OUTPUT
Diagram #2
B
O
NK
BR
GND
V+
N
O
(OUTPUT)
(INPUT NECK PICKUP)
(SHIELD=GROUND)
(INPUT BRIDGE PICKUP)
(WHITE WIRE=SIGNAL)
Soldering to the Input/Output Buss
If you have an older EMG Pickup without connectors, you can connect the
to the Input/Output buss by soldering to the pads provided.
Diagram #1
OUTPUT CABLE TO
MASTER VOLUME
O
NK
BR
GND
V+
.750
1.325
.725
B
N
O
OUTPUT CABLE TO JACK
Diagram #2 (Separate Volumes for each Pickup)
This diagram shows the pickups plugged into the volume controls, then
into the Input/Output buss (Positions 1 and 2). Use diagram #2 If your
guitar has a separate Volume control for each pickup. The output of the
buss (Position 3) can go directly to the output jack as shown in diagram #2,
or it might go to a Master Tone Control, then to the output jack.
Diagram #3
B - Bridge P/U
N - Neck P/U
O - Output
- Ground
N
NK
BR
O
GND
B
O
