Contact us.
Goole Office, Showroom & Factory
01405 746000
London Office & Showroom
0207 490 4909
Email. [email protected]
www.elite-furniture.co.uk
Progress Plus Advanced Keypad User Guide
Using the keypad, hold button until the base reaches the lowest point. Continue to hold button until the LED display
flashes “RST”.
Press and hold button (for upto 5 seconds). The handset should display either:
10.5 - 10kg (high sensitivity) | 10.6 - 15kg (medium sensitivity) | 10.7 - 20kg (low sensitivity)
Hold button until the desired sensitivity setting is shown, then release the button.
To complete the process, hold button until the desk lowers then slightly rises.
Setting the Base Sensitivity
Lock/Unlock the Keypad
To lock the keypad, press and hold button for 8 seconds until the LED display switches to “S hyphen” and then to “LOC”.
Release the button.
To unlock, press and hold button for 8 seconds until the LED display switches to display the height display. Release the
button.
Setting Upper & Lower Height Restrictions
To set a lower height restriction, press and hold until the desired height is reached. Press , followed by .
Complete the process by holding until the display flashes ‘000’.
To set an upper height restriction, press and hold until the desired height is reached. Press , followed by .
Complete the process by holding until the display flashes ‘999’.
To reset the height restriction, press and release. Then hold until the LED display shows ‘555’.
Select Units (inches/cm)
Press the button until the base reaches its lowest position. Press the button again for 5 seconds until the LED flashes
“RST”.
Press and hold the button to switch settings. The display will automatically return to flashing “RST”.
Press the button until the base has lowered a little more and then slightly risen. The new setting will be displayed.
Repeat the process to switch back.
Setting a Memory Preset
At the desired height, press the button once. The display will change to “S hyphen”. Select and press one of the memory
preset buttons (1, 2 or 3). The position has been saved.
The preset positions can now be used by pressing the relevant button (1, 2 or 3).
Using the and buttons, move the base to the next desired position and repeat the process.
M
M
M
M
M
M
M
-
-
M
-
-
-
2
M
+
-
-
-
-
+
+
+
+
Rev. 2
