Mounting onto wall
Using the rear keypad plastic case
as a template, mark the positions
of the mounting holes. The
mounting surface must be solid, do
not mount onto a flammable or
uneven surface. Drill mounting
holes and fit wall plugs, before
drilling make sure you wear safety
goggles and check for hidden cable
and pipes.
K6600
4
3
2
1
5
9
8
7
6
0
PROG
MEN
OMIT RESET
SET
Opening the keypad
To remove the front cover, insert a
flat headed screwdriver to release
the pegs located at the bottom of
the keypad.
K6600 LCD Keypad Installation Instructions
Description
The K6600 LCD keypads can be connected to both the ST6100 & ST6600 control
panel. Up to a maximum of 6 Keypads can be connected to anyone control panel. The
keypad features, 32 segment LCD display, back light illumination, power, system status
and omit LED indication, onboard personal alarm (press: SET, OMIT, SET).
Installation instructions:
Handling the keypad
l
Make sure your hands are clean
l
Handle keypad carefully the LCD display is fragile
l
Do not use unnecessary force when opening and closing the plastic case
l
Peel off the protection film covering the LCD display
l
Set the addressable configuration jumpers
l
Install the keypad close to your entry/exit point of the building,
it should be positioned out of reach of children.
