Thank you for purchasing the ATA SecuraCode
®
Wireless
Digital Keypad. Familiarise yourself with the following
instructions prior to commencing set up. Store this information
including codes in a safe place for future reference.
OPERATION
To open a door or gate using the keypad transmitter simply
enter a valid code via the numerical buttons followed by one of
the programmed channel buttons. Up to 20 individual codes can
be stored in the keypads memory.
The keypad is supplied with a factory preset code (1111)
which must be changed to a new number before the
keypad will operate. A code can be any 4-8 digit code except
8888 8888. Refer to the initial set up sequence below.
INITIAL SET UP
1.
Press and hold Channel 1 (CH1) (Fig. 1) until a long beep
is heard.
2.
Press 1111 then CH1.
3.
Enter new code (eg 1234) then CH1.
4.
Repeat Step (3) to confirm.
ADDING A NEW OR ADDITIONAL CODE
A user code can be any number of 4 to 8 digits except 1111 or
8888 8888.
1.
Wait for the current code to timeout (if one is entered).
2.
Press and hold CH4 until a long beep is heard.
3.
Enter any existing code followed by CH4.
4.
Enter the new code followed by CH4.
5.
Repeat step 4 to confirm.
6.
Test operation using the new code.
CHANGING A STORED CODE
One code must remain in memory for adding, changing or
deleting additional codes.
WARNING:
Changing a code to 8888 8888 will delete it.
Note:
There is a timeout of approximatey 10 seconds after the
last button is pressed.
1.
Press and hold CH1 until a long beep is heard.
2.
Enter the code that is to be changed followed by CH1.
3.
Enter the new code followed by CH1.
4.
Repeat step 3 to confirm.
5.
Test operation using the new code. You should hear a
continuous string of beeps.
CODING THE KEYPAD INTO THE OPENER
1.
Press and hold the blue Door Code button on the control
panel of your garage door opener (Fig. 2) or SW1/SW2 on
the receiver board (Fig. 3 & 4).
2.
Enter any existing code then press one of the four channel
buttons (CH1 - CH4) you wish to use to operate the door or
gate etc.
3.
Press the same CH again.
4.
Release Door Code or SW button. The CH button should
now be stored into the opener's memory.
5.
Test operation of the Keypad. Enter a valid code followed by
the stored CH button.
Note:
You only need to program the CH button once as all users
will have the same access privaleges once a valid code
has been entered.
KPX-5 Wireless Digital Keypad Instruction Manual
KPX-5 Wireless Digital Keypad Instruction Manual
KPX-5 Wireless Digital Keypad
GDO-2 & GDO-4 Garage Door Opener Control Panel
CRX-2 Stand Alone Receiver
SW1 SW2
RX-2 Receiver Board
SW1 SW2
Fig. 1
Fig. 2
Fig. 3
Fig. 4
