WARNING:
Failure to follow Eaton process and product instructions and
limitations could lead to premature hose assembly failures, resulting in property
damage, serious injury or death. Read and understand the operator’s manual
before attempting to operate any equipment.
LIFTING INSTRUCTIONS:
Place pallet on level surface prior to unbolting.
Gloves are recommended for the unbolting process. Lag bolts are located at
each of the 4 corners of the machine base. Remove the lag bolts using a ½”
open end wrench or socket. Be careful when lifting machine so that it does not
tip over. Do not lift by hand. When moving the machine, secure the crimper to a
forklift. Any straps used to aid in the lifting process should not be placed around
the electrical box, which is positioned on the left side of the crimp machine.
SETUP AND INSTALLATION:
1. Mount your Eaton FT1380e crimp machine onto a stable work surface that will support at least 300 pounds.
Secure the unit using the holes provided in the corners of the crimp machine base.
*Ensure crimp machine placement allows adequate access to the electrical box per OSHA and local regulations.
CRIMP MACHINE DIMENSIONS
Width:
16.062 inches
Depth:
25.75 inches
Height:
29.875 inches
Weight:
222 pounds
2. Remove the plug from the hydraulic reservoir vent port and replace it with the vent cap that is supplied with the unit.
CAUTION: Failure to do so will cause cavitation and damage to the pumping mechanism. Hand tighten the vent cap.
The FT1380e machine comes pre-filled with Hydraulic Oil. The MSDS can be found at
eatoncrimpersupport.com
.
3. Plug the machine into a dedicated outlet. Never use an extension cord, always plug directly into the power outlet.
CAUTION: Provide electrical service with a dedicated circuit (per the crimp machine electrical requirements) to
eliminate the possibility of a low-voltage situation.
ELECTRICAL REQUIREMENTS:
FT1380e-115, FT1380e-115CSA:
115-Volt AC single phase (50/60) Hz Circuit with a minimum of 20 amps
FT1380e-230, FT1380e-230CSA:
208 to 230-Volt AC single phase (50/60) Hz Circuit with a minimum of 15 amps
Eaton FT1380e
Electronic crimp machine start-up sheet
SEE BACK FOR OPERATOR’S INSTRUCTIONS
