![background image](http://html.mh-extra.com/html/easypro/ps1uv/ps1uv_manual_524017001.webp)
Thank you for your purchase of the 36 watt UV option for the PS1FB and PSA5000 skimmers. A UV is effective by emitting
intense light which kills algae cells as they pass by the light. If the water is moving by the light to fast it will not provide enough
contact time with the light to be effective. Therefore, while these skimmers can handle greater flows, it is recommended that
when using the UV option you do not exceed 60 gpm of flow to maximize effectiveness. Be sure to keep skimmer net and filter
brushes as clean as possible to prevent restricted flow.
DANGEROUS ULTRAVIOLET RADIATION — Never look directly at the lamp rays, radiation from this UV lamp is
harmful to eyes and skin. Turn off power before handling or servicing unit.
While the transformer is weatherproof — it is not waterproof and is not intended to be submerged in water.
Water level must remain high enough to cover entire quartz sleeve to prevent unit from overheating and causing damage.
Components
• UV Unit Housing
• 36 Watt UV Lamp - Replacement Part # EP36B
• Quartz Lamp Sleeve - Replacement Part # EP36S
• Transformer - Replacement Part # PS1UVT
Installation
1. Unpack housing and remove retainer cap in the top of the unit.
2. If installing unit to PSA5000 you must remove the two tabs on the sides of
the unit using a jigsaw or hacksaw. See picture to right. If installing unit to
PS1FB do not remove these tabs, proceed to step 3.
3. Use a clean rag to insert UV lamp into fixture. Gently insert and tighten the
retainer cap back into place on the housing.
NOTE: Do not touch the UV lamp with your bare hands as this can significantly reduce the life of the lamp.
4. The UV housing slides down into the skimmer in place of the PVC rack that is included with the skimmer. Remove the PVC
rack and store for future use. Slide the UV housing into
the same slots with the rounded side of the rack facing
towards the pump.
5. The cord from the UV goes over the top lip of the skimmer
and over to your electrical supply. The transformer on the
end of the power cable should be hung off the ground but
is weatherproof so no further protection from the weather
is needed.
Maintenance
Over time the quartz sleeve can become coated with minerals and buildup from the water. Carefully remove the sleeve and
clean as needed to ensure the light rays are not blocked by this buildup. The UV lamp will typically last for twelve months of
continuous use. The lamp may still light after this time but the effectiveness of the UV will be reduced. The lamp and quartz
sleeve can be easily replaced when needed, see replacement part numbers above.
Winterization - In freezing climates, remove the entire UV unit from the skimmer and store indoors over winter. Replace the PVC
rack into the middle slots in the skimmer body.
UV Option for PS1FB & PSA5000 Skimmers
Instructions for Installation
PS1UV
Front - flow in
Remove these tabs for
PSA5000 installation
Back - flow out
www.easypro.com
Only operate UV
when water level
falls between
these lines.