DS Services of America Pure Water Dispenser 500 Series, How To Clean

Page: 1 / 2

4. Remove cup holders, if applicable.
Open the cooler lid using the key
provided in the replacement kit (Fig 4) .
5. Close cooler door. Place a glass or other
container below the water faucets to
catch any drips.
Fig 2
Fig 5 Fig 4
Fig 3
Fig 6
Fig 1
Your water dispenser exterior should be thoroughly cleaned at least twice a year, and your
SmartFlo™ water cartridge replaced every 12 months. If you do not have a replacement cartridge
handy, you can order one here and it will be delivered directly to you. Your replacement kit will
include a SmartFlo™ cartridge, bottle adaptor, lid key and plug for the bottle tube:
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
TIP: Have a bucket nearby to
dispose of the used SmartFlo
™
cartridge and bottle tube,
which will contain water.
DIY: HOW TO CLEAN
YOUR WATER DISPENSER
TIP: The best time to replace your water cartridge is when the existing water bottle is empty.
WHAT YOU’LL NEED:
• SmartFlo™ replacement cartridge
• 70% rubbing alcohol or disinfecting wipes
• Clean cloth or soft brush
• Disposable non-latex gloves • Bucket
• Heat-resistant container to fit under spigots
• Towels to absorb any water spills
1. Slide the cooler door up and turn off
the hot tank heater switch (Fig 1) .
Let the unit stand for one hour
before cleaning to allow the hot
tank to cool.
2. Remove the empty water bottle
(Fig 2) . Wipe interior cabinet
with 70% rubbing alcohol or
disinfecting wipes.
3. Unplug the bottle tube connected
to the neck of the water bottle.
Plug the bottle tube using the red
plug provided in the SmartFlo™
replacement kit (Fig 3) .
6. Remove the SmartFlo™ cartridge
and bottle tube by unlatching
the blue locking arm and rotating
the two blue knobs to the open
position (Fig 5) .
7. Pull up on the SmartFlo™ water
cartridge (Fig 6) . Do not squeeze
the water reservoir as water could
leak out.
WARNING: Always use caution when handling hot water.
®