DESCRIPTION
Figure 1: 265LTE PCB
1
INSTALL THE 265LTE
Caution:
Touch grounded metal to discharge
static before handling the XTLplus.
1.
Place the antenna onto the 265LTE SMA
connector and then twist the antenna until it
is securely tightened.
2.
Slide the 265LTE into the XTLplus eight-
pin CELL MODULE connector, keeping the
265LTE parallel to the XTLplus.
3.
Align the standoff hole in the 265LTE with
the standoff on the XTLplus, and then snap it
into place. See Figure 2.
The 265LTE Series Cellular
Communicator provides
a fully-supervised alarm
communication path over an
LTE network.
The 265LTE is installed on
the XTLplus
TM
and powered
by the panel so no additional
enclosure, power supply, or
battery back-up is needed.
Compatibility
XTLplus Series panels with
Version 212 and higher.
Figure 2: Installing the 265LTE
on the XTLplus
What is Included
•
265LTE Cellular
Communicator
•
External Antenna
RESET
LOAD
B
AT
PROG
R B
+ DC -
S
N
External
Antenna
SMA
Connector
Eight-Pin CELL MODULE
Connector
Standoff
Hole
2
ACTIVATE THE 265LTE
Cellular service is required before using the 265LTE
for signal transmission. The 265LTE comes ready for
activation with SecureCom
TM
Wireless. Use Remote
Link
TM
, the Dealer Admin
TM
site (DMPDealerAdmin.
com), the Tech APP
TM
, or call DMP Customer Service
(1-866-266-2826) to activate the 265LTE.
Remote Link Activation
1.
Navigate to Remote Link and select a panel.
2.
Select
Program
in the top menu and select
Communications
from the drop-down
menu.
3.
Select
Cellular Network
as the
Communication Type
and click
Activate
.
4.
Select
SIM
as the
SIM Type
.
5.
Enter the
SIM
number found on the 265LTE
label and click
Activate
.
6.
Select a
Rate Plan
for the 265LTE and click
Activate
.
265LTE SERIES CELLULAR
COMMUNICATOR
Installation Guide
