1128INT WIRELESS GLASSBREAK DETECTOR
Installation Guide
GET STARTED
Figure 1: 1128INT Glassbreak Detector
The 1128INT Wireless Glassbreak
Detector is a fully-supervised,
low current shock and glassbreak
sensor that provides detection
coverage up to 20 ft from framed
glass mounted in an outside wall.
The 1128INT features 128-bit AES
encryption.
You can mount the detector on
the ceiling or an opposing wall for
maximum flexibility and coverage.
The 1128INT operates using the
supplied 3.0 V lithium battery.
Compatibility
•
1100XINT Wireless Receivers
Version 700 and Higher
•
1100DINT Wireless Receivers
Version 700 and Higher
•
XT30INT Series Panels Version
693 and Higher
•
XTLtouchINT/XTLplusINT Series
Panels Version 693 and Higher
•
XR150INT/XR550INT Series
Panels Version 693 and Higher
What is Included?
•
One 1128INT Wireless
Glassbreak Detector
•
One 3.0 V Lithium CR123A
Battery
•
Hardware Pack
1
PROGRAM THE PANEL
Refer to the panel programming guide as needed.
1. If using an XT Series International Panel, enter
665
(PRO) at
the keypad to access the
PROGRAMMER
menu. If using an
XR Series International Panel, enter
6653
(PROG).
2. Press
CMD
until
ZONE INFORMATION
displays and press a
top row select key or area.
3. Enter the wireless
ZONE NO
and press
CMD
.
4. Enter the
ZONE NAME
and press
CMD
.
5. Select
NT
(Night) as the
ZONE TYPE
.
6. Select the
AREA NO
and press
CMD
.
7. At
NEXT ZN?
, select
NO
and press
CMD
until
WIRELESS?
displays.
8. Select
YES
when
WIRELESS?
displays and press
CMD
.
9. Enter the eight-digit
SERIAL#
and press
CMD
.
10. Enter the
SUPRVSN TIME
and press
CMD
.
11. At
NEXT ZN?
, select
YES
if you are finished programming
the zone. Select
NO
if you would like to access additional
programming options.
12. In
SYSTEM OPTIONS
, at the
1100 ENCRYPTION prompt
,
select
ALL
to only add encrypted wireless devices to the
system. Select
BOTH
to allow both encrypted and non-
encrypted wireless devices to be programmed.
13. The default passphrase appears at
ENTER PASSPHRASE
.
Press
CMD
to keep the default. Press any select key or
area to change the passphrase and enter an 8-character
hexadecimal string (0-9, A-F).
Use a 3.0V lithium battery, DMP Model CR123A, or the equivalent
battery from Sony or Murata. When setting up a wireless system,
program zones and connect the receiver before installing batteries
in the transmitters.
1. Remove the holding screw at the lower end of the 1128INT
case and gently life off the cover. See Figure 2.
2. Observing polarity, place the battery in the holder. Press it
into place. See Figure 3 for the battery location.
INSTALL THE BATTERY
2
Figure 2: Open the 1128INT
LED
Holding
Screw
Figure 3: 1128INT Battery Location
Tamper
Battery
Holder
