1
PS-2000B Series
Installation Guide
Follow the instructions given below to ensure the correct and safe use of the PS-B.
• If the screen becomes dirty or smudged, moisten a soft cloth with diluted neutral deter-
gent, wring the cloth well, and wipe the display. Do not use thinner or organic solvents.
• Avoid storing and operating the PS-B in direct sunlight, high temperatures and
humidity, and in areas where excessive dust and vibration will occur.
• Avoid using the PS-B in areas where sudden, extreme changes in temperature can occur.
This may cause condensation to form inside the unit, possibly leading to an accident.
• To prevent the PS-B from overheating, be sure its air circulation vents are clear
and clean, and keep the unit’s operation area well-ventilated.
• Avoid operating or storing the PS-B near chemicals, or where chemicals can
come into contact with the unit.
• The Digital Electronics Corporation cannot be held responsible or provide any
compensation for damage(s) caused by the loss of data stored in the PS-B unit’s
hard disk drive (HDD). It is therefore strongly suggested that all important data
and software be backed up regularly to an external data backup device.
• After turning OFF the PS-B's power, wait until the internal HDD stops spinning
before turning the power ON again (approx. 5 seconds).
To Prevent Accidents
Follow the instructions given below to ensure the correct and safe use of the PS-
2000B Series unit, hereafter referred to as the “PS-B”.
• To prevent an electrical shock, be sure to connect the power cord to the PS-B
before connecting it to the main power supply.
• A fire or electrical shock may result if voltages are used with the PS-B that are
beyond the specified range. Be sure to only use the specified voltage.
• Before opening the PS-B’s protective cover, be sure to turn the unit’s power OFF.
This is because the PS-B’s internal parts carry high voltages.
• If metal particles, water or other types of liquids contact any of the PS-B’s internal
parts, immediately turn the unit’s power OFF, unplug the power cord, and contact
your local PS-B distributor.
• Read and understand Chapter 4 “Installation and Wiring” thoroughly in order to
select an appropriate installation location for the PS-B.
• Before either plugging in or unplugging an expansion board or interface connec-
tor, be sure to turn the PS-B’s power OFF.
• To prevent a possible explosion, do not install the PS-B in areas containing flammable
gases.
• The PS-B is not appropriate for use with aircraft control devices, aerospace equip-
ment, central trunk data transmission (communication) devices, nuclear power
control devices, or medical life support equipment, due to these devices’ inher-
ent requirements of extremely high levels of safety and reliability.
• When using the PS-B with transportation vehicles (trains, cars and ships), disas-
ter and crime prevention devices, various types of safety equipment, non-life
support related medical devices, etc. redundant and/or failsafe system designs
should be used to ensure the proper degree of reliability and safety.
WARNINGS
