GoboTop, the Mini-Projector
Thank you for purchasing this high-quality product. GoboTop is exclusively
manufactured in Germany and meets the highest quality and safety standards.
We are confident that you will be amazed by the crisp projections produced by
this tiny but versatile projector. Please read these operating instructions first in
order to use the system effectively and safely!
Important Safety Note
Additional tip(s) for the most effective use
of your Mini-Projector.
1
A) Safety precautions:
+
GoboTop is only suitable for dry indoor locations.
+
Use only replacement lamps that are tested and approved by Derksen
Lichttechnik (see section 12). If you operate GoboTop with an unsuitable
lamp, the system will be damaged.
+
Projection head, lamp, socket and fixture heat up during operation. Wait
approx. 15 minutes until the system has cooled down before you handle
gobo, lamp, projection head or fixture.
+
Observe a minimum distance of 0.5 m between the projection head and any
flammable materials or surfaces.
+
Do not cover the rear side of the lamp in order to avoid accumulation of heat.
+
Please make sure that your Halogen low voltage system supports 12V,
30/50W.
,
Only use original accessories made by Derksen Lichttechnik which are
specially designed to be used with GoboTop. When using incompatible
accessories from other manufacturers, injury to persons or damage to
property may result.
,
Ensure that the GoboTop - Mini-Projector is firmly attached to your halogen
lighting system. The multi-mirror lamp must be completely inserted into the
socket.
,
It is obligatory to attach the enclosed safety cable which may retain the
projector (please refer to chapter C in section 11).
,
Wrap the safety cable around a rail or any similar part of your halogen
lighting system. Push the cable through the eyelet in order to close the loop.
,
Attach the hook to one of the four eyelets on the fastening ring ( , ).
How to use the safety cable:
B) Assembly:
GoboTop parts:
Step-by-step assembly:
1.
Remove the multi-mirror lamp.
2.
Remove the fastening ring (8) by turning it counter-clockwise.
3.
Remove the spacer ring (6).
4.
Insert the gobo and arrange the image.
In order to arrange the image properly follow the steps below:
!
The image should be visible/readable from the lamp (see illustration
below, item 5) and should be turned upside down.
!
If a deflection mirror is used, please follow the installation tip in
section 9.
5.
Re-insert the spacer ring (6).
6.
Place the multi-mirror lamp (7) on the spacer ring (6).
7.
Tighten the fastening ring.
focussing rail
lens
light shield
housing
gobo
spacer ring
multi-mirror lamp
fastening Ring
(threaded)
eyelets for
safety cable
3
2
5
7
8
6
4
R
6
6
W
i
W
W
i
