Dell SPR-WL2-MNT, Installation Manual

Page: 1 / 4

Dell Networking SPR-WL2-MNT
Installation Guide
0511741-01 | February 2015
1
This document provides installation instructions for mid-rack mounting and wall mounting the Dell W-7024/W-
7205 controller using the SPR-WL2-MNT accessory kit.
The W-7024/W-7205 controller is referred to as "device" in rest of the document.
Package Contents

Two mid-mount brackets

Two wall-mount brackets

Eight M4 x 8 mm Phillips flat head screws

Four M6 cage nuts

Four M6 clip nuts

Installation Guide (this document, printed)
Mid-Mount Rack Mounting
This option allows mounting the device from the middle in a standard two-post 19" Telco rack.
Required Tools and Equipment

Two mid-mount brackets

Eight M4 x 8 mm Phillips flat head screws

Four M6 x 15 mm Phillips pan head screws (not included in this package, included in the device package)

Four M6 cage nuts (optional)

Four M6 clip nuts (optional)

Suitable screwdrivers (not included in this package)
Installation Steps
To install the device in a two-point 19” (48.26 cm) rack system:
1. Place a mid-mount bracket over the mounting holes on either side of the device in the middle (see Figure 1 ).
NOTE: The figures in this document illustrate the installation procedure for the W-7205 controller.The same installation procedure
applies to the W-7024 controller.
NOTE: Some racks require screws that differ from those included with the device. Confirm that you have the correct screws
before installing the device.
CAUTION: Each device should have its own mounting equipment. Do not place other networking equipment directly on top of a
mounted device. Failure to do so can result in damage to the device.