(WTS10)
Daintree
®
Wireless Thermostat
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
1
Installation Process
Installation Guide
WTS10 | DT103
Risk of electrical shock. Disconnect power before servicing or
installing product.
Install in accordance with National Electric Code and local codes.
WARNING
Risk of injury. Wear safety glasses and gloves during installation and
servicing.
CAUTION
The
WTS10 Wireless Thermostat operates seamlessly within the
Daintree Networked wireless building control platform. The WTS10
is a low voltage wireless commercial programmable thermostat
that can connect to any single or multi-stage conventional or heat
pump HVAC system. As part of the Daintree Networked platform
and using industry standard ZigBee
®
wireless communications, the
WTS10 can be managed and programmed from any location using
the ControlScope Manager (CSM) web application, eliminating the
need for on-site, manual thermostat adjustment.
If this is a new thermostat installation, locate the thermostat
4 to 5 feet above the floor in accordance with applicable building
codes. Install in a location that provides good airflow characteristics
and avoid areas behind doors, near corners, air vents, direct sunlight,
or heat generating devices. Installation in these areas could impact
thermostat performance. Wiring must conform to all building codes
and ordinances as required by local and national code authorities
having jurisdiction for this installation.
1.
Always turn off power to the air conditioning and/or heating
system prior to installing thermostat.
2.
Determine the HVAC equipment type.
Note to Installer:
Circle
the type of equipment and give this information to the
commissioning agent:
A. 1 Stage Heat / 1 Stage Cool Conventional System
B. 2 Stage Heat / 2 Stage Cool Conventional System
C. 3 Stage Heat / 2 Stage Cool Conventional System
D. 1 Stage Heat / 1 Stage Cool Heat Pump System (with
out Auxiliary Heating)
E. 2 Stage Heat / 1 Stage Cool Heat Pump System (with
Auxiliary Heating)
F. 2 Stage Heat / 2 Stage Cool Heat Pump System (with
out Auxiliary Heating)
G. 3 Stage Heat / 2 Stage Cool Heat Pump System (with
Auxiliary Heating)
3.
Refer to the
Wiring: Thermostat Terminals
section to deter
mine the number of wires necessary to install this thermostat
with your system.
• A common connection between the HVAC unit and the
thermostat “C” terminal is required.
• When replacing an existing thermostat, and before
disconnecting any wires, mark each wire connected to
the existing thermostat with the terminal letter to which
it is connected.
• Make sure the disconnected wires do not slip back
through the wall opening; anchor them outside the
wall opening.
4.
Ensure that power to the air conditioning and heating
systems is turned off.
5.
Mount the WTS10 thermostat.
A. Remove the thermostat front body from the base.
B. Guide thermostat wires through the center opening in
the base. Anchor them so they do not slip back into the
wall.
C. Hold the thermostat base against the wall in the desired
thermostat location.
D. Mark placement of mounting holes as appropriate.
E. Remove thermostat base from the wall. Install wall
anchors as required at the mounting hole locations.
F. Re-insert the wires through the center opening on the
base. Anchor them so they do not slip back into the wall.
G. Fasten the base to the wall using the supplied #6 screws
into the wall anchors.
6.
Refer to
Wiring: Thermostat Terminals
and wire the terminals
on the thermostat base to the attached HVAC equipment.
