![background image](http://html1.mh-extra.com/html/curt-manufacturing/58987/58987_installation-manual_2699040001.webp)
58987-INS-RA
•
04/20/2021
•
ECN8140
•
PAGE 1 OF 4
INSTALLATION MANUAL
Tools Required
Drill
Fishwire
Drill bit, 3/32"
Electrical tape
Panel trim
removal tool
Cutting tool
Wiring Location(s)
T5
Product Photo
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
Maintenance
Periodic inspection of all wires and connections should be performed
to ensure there is no visible damage or loose connections.
Wiring Location Guide*
for Trucks (T)
T1 Behind driver side taillight housing
T2 Behind passenger side taillight housing
T3 Behind driver side rear bumper
T4 Behind center of rear bumper fascia
T5 Behind passenger side rear bumper
T2
T4
T5
T1
T3
* Representative vehicle shown
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.