Perfect For
•
Thin cuts of meat, fish or poultry
Easy To Use
•
3-6 second response
•
Backlit in blue
•
Extra big digit
•
Temperature guide
Features
•
NSF
®
Certified
•
1.5 mm thin tip
•
4.25"/10.8 cm stainless steel probe
•
Water resistant
•
Shatterproof
•
Maximum & minimum
•
Food-safe ABS plastic with BioCote
®
•
Field calibration
•
On/off button
•
Auto-off after 10 minutes
•
Mounting: loop
•
Batteries & instructions included
Note:
Remove sticker from display before use.
Get Professional Results
Every Time!
Perfect for thin cuts of meat, fish or poultry. Simply
flip down the rapid-response thermocouple probe
and insert it into food as thin as 1/8-inch. BioCote
®
technology gives the water resistant housing
constant, built-in antimicrobial protection, providing
a finish that helps prevent microbes from growing on
the surface. The display features extra big digits and
can be backlit for low light conditions.
The TCT572 offers Minimum and Maximum modes.
Minimum mode displays the lowest temperature
among multiple readings. Maximum mode displays
the highest temperature among multiple readings.
Note:
In the following instructions, names of the control
buttons are shown in CAPS. Function information that appears
on the display is shown in
BOLD CAPS
.
Battery Installation
Power off the unit before installing the battery.
A malfunction may occur if the power is on when
the battery is installed. If a malfunction occurs, press
the RESET button on the back or restart the device.
1. Using a small Phillips screwdriver, remove the
screw on the top by turning it counter clockwise.
2. Pull side panel completely out.
3. Install two CR2032 batteries observing polarity
shown in compartment.
4. Replace the battery cover.
Important:
The water resistant feature requires
maintaining the rubber gasket evenly within the
groove.
5. Fasten the screw on the top by turning it
clockwise, being careful not to over-turn.
Model: TCT572
ProAccurate
®
Folding
Thermocouple Thermometer
-58 to +572°F/-50 to +300°C
