![background image](http://html.mh-extra.com/html/casio/3311/3311_operation-manual_2570948001.webp)
Operation Guide 3311/3356
1
MA0406-EA
•
The display will automatically revert to the Timekeeping screen if you leave the Battery Level, Alarm, or Hand Setting screen displayed
without performing any operation for about two or three minutes.
Each press of the
C
C
C
C
C
button sounds a confirmation tone and cycles through available modes in the sequence shown below.
Timekeeping Mode
•
For more information, see “To configure digital settings”.
Days of the Week
SU: Sunday
MO: Monday
TU: Tuesday
WE: Wednesday
TH: Thursday
FR: Friday
SA: Saturday
Or
Calendar Screen
Current Time Screen
Seconds Screen
❚
Changing Display Screen Contents
Each press of the
button cycles digital display contents in the sequence
shown below.
Button
Button
Button
Button
Second Hand
Minute Hand
Hour Hand
Digital Display
Day of the Week
Day
Day of the Week
Seconds
Hour
Minutes
PM indicator
(no indicator for AM)
(Light)
Receive Icon
(Indicates time calibration
signal reception was
successful.)
Modes and Display Screens
❚
Start charging at Level 3!
Battery Level 3 indicates that remaining battery power is very low.
Be sure to expose the watch to light for recharging as soon as
possible after the Level 3 indicator starts to flash.
❚
Flashing Recover Indicator
If you use the light or alarms a number of times during a short
period, a recover (R) indicator flashes on the display and the
following operations become disabled as battery power recovers.
•
Display illumination
•
Alarm and hourly time signal
•
Analog timekeeping
•
Time calibration signal reception
Normal operation will return after the
battery recovers.
❚
Charging Precautions
Avoid charging the watch in the following locations, and anywhere
else where the watch may become very hot.
•
On the dashboard of an automobile parked in the sun
•
Very close to an incandescent light source or other sources of
heat
•
In a location exposed to direct sunlight for long periods
Note that the display panel may become black under very high
temperatures. This is temporary, and the display will appear
normal again at lower temperatures.
Depending on the light source you are using, the
case of the watch may become quite hot during
charging. Take care to guard against burn injury after
charging.
❚
To charge the battery
Point the solar panel (face) of the watch at a light source.
•
Remember that even a partial blockage of the solar cell reduces
charging efficiency.
Example: Positioning the watch
Solar Cell
•
The illustration shows the resin band model.
The power supply of this watch uses a solar cell to generate
electrical power, which is stored by a rechargeable battery. Using
or storing the watch where it is not regularly exposed to light, or
allowing it to be blocked from light by your sleeve for long periods
as you are wearing it can cause the power of the rechargeable
battery to run down. To ensure stable operation, be sure to allow
the watch to be exposed to light as much as possible when you
are wearing or storing it.
Important!
Note that all data in memory and all settings are cleared whenever
you allow the level of the rechargeable battery to drop to Level 4.
❚
Checking the Battery Level
Use the Battery Level Screen to check the current level of the
watch’s rechargeable battery.
•
In the Timekeeping Mode, press the
C
button once to change to
the Battery Level Screen.
Battery Level Screen
Timekeeping Mode
Or
Example: Day of the Week
Normal operation enabled.
Normal operation enabled.
Signal reception, tones (alarms,
hourly time signal), display
illumination, digital display, and
analog timekeeping disabled.
All functions, including
timekeeping, disabled.
Level 1
Level 2
Level 3
Level 4
•
Exposing the watch to direct sunlight or other strong light may
cause the battery level indicator to momentarily indicate a level
that is higher than the actual battery level. Because of this, you
should wait for a short while after charging to check the battery
level indicator.
•
Alarms and the hourly time signal cannot be turned on, and signal
reception is disabled while the battery is at Level 3.
•
Signal reception will become enabled again when the battery is
recharged up to Level 2.
•
Even after the battery drops to Level 4, watch operation will
resume as soon as charging starts. However, you should wait until
the digital display operation resumes before setting the time and
date.
Power Supply
Recover (R) Indicator
Alarm Mode
World Time Mode
Battery Level Screen
Stopwatch Mode
Hand Setting Mode
Or
City Code
Alarm
Number
Mode
Indicator
Mode Indicator
2-second
interval