background image

Operation Guide 2886

1

Introduction

Thank you for purchasing this CASIO product. To ensure that it can
provide you with the years of service for which it is designed, be sure to
read this manual carefully and follow the instructions contained herein.
Make sure you read the Safety Precautions before using this product for
the first time.

Note that the measurement functions of this product are not
intended for use in applications where special instruments are
required. The readings produced by this product are reasonably
accurate approximations only.

Safety Precautions

 Warning!

Do not use this product while scuba diving (aqualung).

This product is not a diving watch. Improper use of this
product can lead to serious accident.

Built-in battery

Never try to remove the watch’s rechargeable (secondary)
battery. Leave all built-in battery replacement operations up
to your original retailer or authorized CASIO service center.

Whenever the watch’s built-in battery is removed from the
watch, take care to ensure that it is not swallowed
accidentally. Special care is required where young children
are present.

Keep batteries out of the reach of small children. Should a
battery ever be swallowed accidentally, contact a physician
immediately.

AC Adaptor and Charger Unit

Should you ever notice any abnormality such as smoke,
strange odor, or excessive heat being emitted by the AC
adaptor or charger unit, immediately unplug the AC adaptor
from the power outlet and contact your original retailer or
authorized CASIO service center.

Do not allow long-term contact between your skin and the
AC adaptor or charger unit while it is conducting electricity,
or with the watch while it is being charged. Long term
contact creates the risk of low-temperature burn injury.

 Warning!

AC Adaptor and Charger Unit

Never allow water or foreign matter to get inside the AC
adaptor or charger unit, and do not allow them to become
wet. Should water or foreign matter get into the AC adaptor
or charger unit, immediately turn off power, unplug the AC
adaptor from the power outlet, and contact your original
retailer or authorized CASIO service center.

Failure to observe the following points concerning the AC
adaptor and charger unit creates the risk of fire and
personal injury.

Do not use or leave the AC adaptor or charger unit near
a heater or any other source of heat.

Do not use or leave the AC adaptor or charger unit in a
bathroom, near a humidifier, or in any other location
where it is exposed to splashing water or moisture.

Never touch the AC adaptor or charger unit while your
hands are wet.

Never expose the AC adaptor or charger unit to flame or
heat.

Never try to take the AC adaptor or charger unit apart or
modify it in any way.

Never short AC adaptor or charger unit terminals through
contact with needles, pins, or other metal objects.

Take care not to drop the AC adaptor or charger unit or
otherwise subject it to strong impact.

To ensure safety during lightning storms, unplug the AC
adaptor from the power outlet.

Be sure to grasp the plug when unplugging the AC
adaptor.

Never use the watch, AC adaptor, or charger unit while it
is covered by a blanket, etc.

Keep the AC adaptor and charger unit out of the reach of
small children.

Be sure to unplug the AC adaptor from the power outlet
before leaving on a trip or otherwise leaving it
unattended for long periods.

 Caution!

Caring for Your Watch

A dirty or rusty case or band can soil the sleeve of your
clothing. Be sure to keep the case and band clean at all
times. Rust tends to form easily after the watch is exposed
to seawater and then left without cleaning.

Skin Irritation

Since the watch and the band come into direct contact with
the skin, the following conditions may cause irritation of the
skin.

When a wearer is allergic to metal or leather

When the watch or band is rusty dirty, sweaty, etc.

When the wearer is in poor physical condition

Tightening the band too tightly can cause you to sweat,
and can make it hard for air to pass under the band,
which can lead to skin irritation. Do not over-tighten the
band.

The bacterial and odor resistant band suppresses the
formation of organisms and bacteria due to sweat, and
related odors. It does not protect against skin rash.

Should you ever notice any abnormality, immediately
stop using the product and consult a physician.

Using the Auto Light

It is recommended that you turn off the Auto Light while
driving or riding in a motor vehicle. Unintended illumination
can distract the operator and create the risk of traffic
accident.

Never try to take the watch apart!

Never try to take the watch apart. Doing so creates the risk
of personal injury and malfunction of the watch.

MA06

09

-EB

Symbols

This manual and the product itself use various symbols that are intended
to ensure safe operation of the product, to prevent injury to you and
others, and to protect against material damage and loss. The following
explains the meanings the symbols.

Example Symbols

The   symbol indicates a caution. The symbol to the left
indicates an electric shock caution.

The   symbol indicates something you must not do. The
symbol to the left indicates that you should not try to
disassemble something.

The   symbol indicates something you must do. The
symbol to the left indicates that you must unplug the
power cord from the power outlet.

Disregarding information with this label creates
the risk of death or serious personal injury.

Disregarding information with this label could
possibly create the risk of death or serious
personal injury.

Disregarding information with this label could
possibly create the risk of personal injury or
material loss.

Danger!

Warning!

Caution!

Summary of Contents for 2886















Reviews: