background image

2 – SET-UP SCREENS

AFS AccuControl Anhydrous Ammonia  

AFS Pro 700 Quick Reference Card  

(v28.* and after)

REQUIREMENTS

The following actions are required for proper operation. Working 
through this document in order will properly set up your 
anhydrous ammonia (NH

3

) system for application. This guide is to 

be used as quick reference only. Insert a data card in the display 
before turning the display on.

DANGER!
1.

  Anhydrous Ammonia (NH

3

) Under Pressure. Anhydrous 

ammonia can cause severe burning, blindness, or death. 
Carefully read and follow all safety instructions and warnings 
before operating or servicing equipment.

2.

  Always wear proper personal protective equipment when 

working with Anyhydrous and anhydrous ammonia. 

1 – GENERAl NAvIGATIoN

1.1 Main Screens

Main screen

Status/Warnings

Navigation Bar

Left Hand Ar

ea

2.1 operator

Toolbox>oper

a)  Create an operator
b)  Select preferred  

units of  
measurement

2.2 GPS Setup

Toolbox>GPS

a)  Verify GPS Location
b)  Verify Offsets
c)  Verify DGPS Type

3 – ANhyDRoUS CoNfIGURATIoN

3 – ANhyDRoUS CoNfIGURATIoN – continued

Toolbox>AccuCtrl
 Note:

 Activation is required (

Toolbox>Activate

)  

 prior to these steps.

3.1 Basic Setup

a)  Select AccuCtrl Operation  

[Anhydrous] 

b)  Select AccuCtrl Installed  

[Yes]

c)  Create New Implement
d)  Select Implement Type  

[Anhydrous Toolbar]

3.2 Implement Configuration

a)  Press ‘Setup’
b)  Select Drive Type 
c)  Select Vehicle Type
d)  Set Number of  

Drive Sections [A]

NoTE!

 Section Control  

information entered in 3.3.

e)  Set Total Number  

of Rows [B]

f)  Enter Row Width [C]
g)  Enter Bar Distance in Inches  

(axle to knife) [D]

NoTE! 

Verify GPS Offset (

Toolbox>GPS

)

h)  Measure Implement Right/Left Offset [E]
i)  Enter Rows Per Drive Section
j)  Press ‘Done’

NoTE: The next setup steps may or may not be needed.  
The configuration of the Nh

3

 toolbar determines the need 

for setup. If the toolbar is not equipped with the capability, 
leave the setup as ‘No’.

3.3  Section Control Setup  
(If equipped with Section Shutoff valves)

a)  Select Row Clutch [Yes]
b)  Press ‘Setup’
c)  Assign Module  

Serial Numbers  
(starting w/modules  
on LH side)

d)  Assign Rows Per Output  

(Number of Rows  
per Group)

e)  Select Control Polarity 

Note:

 Active On is common  

for Section Control Valves.

f) Select ‘Done’

Reviews: