CANOPY US LED CNP-1-50 Series Installation Manual Download

Page: 1 / 4

INSTALLATION GUIDE

CNP-1-50

Page 1

Updated 09.21.12

#44-000017

The installation must only be performed by a licensed electrician.

To prevent death, injury or damage to property, this product must be installed in accordance to National

Electrical Code (NFPA70) in the US or Canadian Electrical Code (CSA22.1) in Canada.

Disconnect power before installing the product or servicing it.

Wait until fixture has cooled down before installing or servicing the fixture.

MIN. 90°C SUPPLY CONDUCTORS

WARNING

MODEL NUMBERS

This installation instructions covers the following products:

Power Supplies
1. 50W Power Unit: PUC-UNV1-2100
2. 75W Power Unit: PUC-UNV1-3000
3. 96W Power Unit: PUC-UNV1-3570

Luminaires
1. CNP-1-50 Series Luminaires

BOX CONTENTS

Mounting Plate Assembly

Wire Harness/Cover

Assembly

CanopyStar Fixture

LED Driver with

Mounting Bracket

Tools Needed
1. 4” Hole Saw
2. #2 Phillips Screw Driver
3. ¼” Hex Driver

Summary of Contents for US LED CNP-1-50 Series

Page 1: ...in Canada Disconnect power before installing the product or servicing it Wait until fixture has cooled down before installing or servicing the fixture MIN 90 C SUPPLY CONDUCTORS WARNING l l l l l MODE...

Page 2: ...ver assembly to fit 2 Install mounting plate assembly by folding mounting tabs in insert mounting plate into 4 hole and secure by tightening mounting tab screws using 2 Phillips screw driver See Figur...

Page 3: ...ssembly and make power connections using approved electrical connector Connect Red wire to Red wire and Blue wire to Blue wire See Figure 6 INSTALLATION INSTRUCTIONS FIG 5 FIG 6 FIG 7 FIG 8 6 Pack exc...

Page 4: ...etal screws supplied Insure location allows wire harness to reach low voltage side of power supply box See Figure 10 4 Make internal primary side high voltage power connections by connecting wires Bla...