• SWAY CONTROL CANNOT BE USED ON TRAILERS WITH SURGE BREAKS.
• Trailer loading: Proper trailer loading is your first-line defense against
dangerous instability and sway. Heavy items should be placed on the
floor in front of the axle. The load should be balanced side-to-side and
secured to prevent shifting. Tongue weight should be about 10-15
percent of gross trailer weight for most trailers. Too low a percentage of
tongue weight can cause sway. Load the trailer heavier in front.
• The On/Off handle is an on/off device only. The Tensioning Screw is for
adjustment.
• When towing during slippery conditions such as wet, icy, or snow
covered roads or on loose gravel, turn On/Off handle counter-clockwise
until all tension is removed from unit. Failure to do so could prevent tow
vehicle and trailer from turning properly.
• Do not speed up if sway occurs. Sway increases with speed. Do not
continue to operate a swaying vehicle. Check trailer loading, sway
control adjustment, and all other equipment until the cause of sway has
been determined and corrected.
• Never paint or lubricate slide bar.
CAMCO CANNOT BE HELD RESPONSIBLE FOR ANY DAMAGES DUE TO
IMPROPER USE OR INSTALLATION ON THIS PRODUCT.
Tools for Installation
• Tape Measure
•
11
/
32
" Drill Bit
• Electric Drill
• Appropriate Safety
Protection
• Arc Welder
• "C" Clamps
• Center Punch
• Torque Wrench
• Socket Set
NOTICE
If product components are
missing or damaged do not
return to dealer, contact the
manufacturer.
1-800-334-2004 (ext. 237)
eaz
®
SWAY CONTROL
Adjustable
™
