9628SS_ii_170606
Pg 1
1
9628SS
for use with California Faucets Hot Water Dispensers ONLY
Kitchen Hot Water Dispenser Tank
Installation Instructions
2
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Electrical Supply Outlet Rating:
120V AC @ 15A Min.
†
Recommended Supply Pressure:
20 to 70 psi
††
†
Outlet shall be a
GROUND-FAULT CURRENT INTERRUPTER (GFCI) type
.
††
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
INSTALLATION OF TANK
Warning:
Electrical outlet MUST be a
GROUND-FAULT
CURRENT INTERRUPTER (GFCI)
type OUTLET
(13)
Important:
Make sure temperature DIAL
(6c)
is turned all the way
counter clock-wise to the COLD position before plugging tank into
OUTLET
(13)
Important:
There MUST
be at least a ½” space between
TANK
(6)
and side WALL(S)
(2)
for proper air circulation around TANK
(6)
Warning:
DO NOT store flammable liquids near TANK
(6)
The location of the TANK
(6)
should allow for
direct installation of the hot water dispenser hoses
without making loops or kink in the faucet hoses
The surrounding
WALL(S)
(2)
must be at least a ½”
to allow proper air circulation around TANK
(6)
To prevent TANK
(6)
from accidental falling over it
is recommended to install mounting BRACKET
(3)
to WALL
(2)
and secure with SCREWS
(4)
(not
supplied)
The use of a shallow PAN
(5)
(not supplied) is
suggested, but not necessary
CONNECTIONS TO TANK
As taken from California Faucets CF-9625-KXX Kitchen Hot Water
Dispenser Installation Instruction
Remove and discard from one of the COUPLING
(7)
one ¼” NUT
(7e)
& SLEEVE
(7d)
from the
other COUPLING
(7)
remove & discard
one 3/8”
NUT
(7c)
& SLEEVE
(7b)
Place ¼” compression NUT
(7e)
& SLEEVE
(7d)
onto hot tank INLET
(6a)
slide coupling BODY
(7a)
on and s
ecurely tighten ¼” compression NUT
(7e)
to coupling BODY
(7a)
Place 3/8” compression NUT
(7c)
& SLEEVE
(7b)
onto hot tank OUTLET
(6b)
slide coupling BODY
(7a)
on and securely tigh
ten 3/8” compression
NUT
(7c)
to coupling BODY
(7a)
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING/ELECTRICAL PRODUCTS BE
INSTALLED BY A LICENSED PROFESSIONAL
INLET:
1/4”
Comp.
OUTLET:
3/8”
Comp.
½”
Discard top
nuts & sleeves
