background image

MODEL CS OWNER’S GUIDE

The Com-Pak Plus

SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

The Com-Pak Plus

The Com-Pak Twin Plus

Side

Wall Can Side

Grill Front

Wall Can Bottom

Side

Wall Can Side

Grill Front

TOOLS REQUIRED:

Phillips Screwdriver
Straight Screwdriver
Wire Strippers

Utility Knife
4 1

1

/

2

“ Wood Screws

3 Insulated Wire Connectors
1 Strain Relief Connector

WARNING

Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.

1. Read all instructions before using this heater.
2. Read all information labels. 

Verify that the electrical supply

wires are the same voltage as the heater.

3. All electrical work and materials must comply with the

National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.

4. Connect the grounding pigtail (copper wire) provided in the

wall can to the supply ground wire.

5. If you need to install a new circuit or need additional wiring

information, consult a qualified electrician.

6. Protect electrical supply from kinks, sharp objects, oil,

grease, hot surfaces or chemicals.

7.

WARNING

Overheating or fire may occur. DO NOT 

install the heater in

a floor, behind doors, or outdoors.  

8.

WARNING

Fire or explosion may occur. 

Heater has hot and arcing or

sparking parts inside. Do not install heater in any area
where combustible vapors, gases, liquids, or excessive lint
or dust are present.  

9.

WARNING

Burn Hazard.

This heater is hot when in use. To avoid burns,

do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids and
whenever the heater is left operating unattended.

10.

WARNING

Risk of Electrical Shock.

Keep all foreign objects out of

heater. Do not operate after heater malfunctions or has
been dropped or damaged in any manner.

11.

WARNING

Risk of Fire. Do not block heater. 

Heater must be kept clear

of all obstructions: a minimum of 3 feet in front, 6 inches
above and on both sides. Heaters must be kept clean of
excessive lint, dirt and debris. (See Maintenance Instructions).

12. Use this heater only as described in this manual. Any other

use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.

www.cadetco.com    Tel: 360-693-2505    P.O. Box 1675    Vancouver, WA    98668-1675

Features & Benefits

NEW

Primary and secondary thermal safeguards

Robust, heavy duty high temperature manual 
power reset

Over temperature one-time thermal fuse  

Nichrome element wrapped around mica
insulators for durability

Powder coat paint process eliminates sharp
cutting edges

Two year extended warranty

Wall can designed for ease of installation

Factory tested

MODELS
The Com-Pak Plus (Model CS)

CS051

*CS051T

CS152

*CS152T

CS052

*CS052T

CS202

*CS202T

CS072

*CS072T

CS208

*CS208T

CS102

*CS102T

CS101

*CS101T

CS122

*CS122T

CS151

*CS151T

The Com-Pak Twin Plus (Model CS)

CST252

*CST252T

CST102

CST302

*CST302T

CST152

CST402

*CST402T

CST408

*CST408T

*Standard built-in thermostat is single pole and has 

no “OFF” position

Wall Can 
Bottom

1”

2.54

1”

2.54

9”

22.86

12”

30.48

11½”

29.21

10”

25.4

3¼”

8.26

1¼”

3.18

7

7

/

8

20.00

4”

10.16

3”

7,62

1 ¾ ”

4.45

1 ¼ ”

3.18

10”

25.4

11

1

/

8

28.26

12”

30.48

4”

10.16

14

1

/

2

36.83

16

1

/

4

41.27

7

/

4

2.22

3”

7.62

Summary of Contents for The Com-Pak Plus











Reviews: